Question about 2001 Jeep Wrangler

1 Answer

Have a 2001 Jeep Wrangler. Radio won't start

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Jeep Master
  • 6,360 Answers

Fix your car right away by clicking the link I attached
2001 Jeep Wrangler

Posted on Dec 04, 2017

Ad

6 Suggested Answers

Anonymous

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 319 Answers

SOURCE: 1996 jeep grad cherokee wiper fuse

either on the passanger side or under the hood behind the battery. open them up and read them. They will say which ones they go to.

Posted on Dec 20, 2008

Anonymous

  • 1 Answer

SOURCE: 1998 Jeep Wrangler Electrical Short in Steering Column?

I had a similar problem with my 2000 Jeep TJ and I found the problem in the wiring harness under the hood.several wires were corroded and almost burnt off.If you remove the black tape which keeps the harness bundled together and if you see evidence of "green" type powder or "gook" it's most likely where the wires have faulted.

Posted on Jan 15, 2009

Anonymous

  • 1 Answer

SOURCE: fuse box

Under the left of the dash board close to the parking brake tucked up under.

Posted on Feb 15, 2009

Anonymous

  • 3 Answers

SOURCE: windshield wipers stopped working on 1993 jeep cherokee

Did you plug them all back in? lol j/p

Do your blinkers and your back windshield wipers work? It's either electrical or mechanical. Turn them on and poke around to see if you hear the motor doing anything. If you hear it, it's probably a broken linkage. If not, start with the fuses and work from there.

It's possible that by unplugging the battery and then plugging it back it, the fuse for the wipers received an electrical surge, blowing it. Consult your manual to see where the fuse for your model is and check to see if it's blown.

Posted on Aug 12, 2009

Richard Scordino

  • 6982 Answers

SOURCE: windshield wiper lever broke off steering column

If it's a multi-function switch or a single function arm, you will need to remove the steering wheel to access the attachment points. If you never have done this, get a basic manual such as haynes or chilton. Both have decent instructions to guide you and after, they have lots of good info to help with other problems as well. Since it's an 89, it's doubtful if it has an airbag...that makes things a lot less complicated.

Posted on Nov 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The whipers on my 93 jeep wrangler wont work


when they do not work turn the key to the run position, the vehicle does not need to be running, and the wipers set to high speed whack the wiper motor with the handle end of a large screwdriver. if the motor starts to work replace it.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Nov 30, 2012 | 1993 Jeep Wrangler

1 Answer

Windshield wipers work when fuse is in but won't turn off unless you remove the fuse. Won't pass inspection. Help!


Check the relay relay maybe latched on. See if there is an identical relay in the box and swap them if problem goes away replace relay.

May 23, 2012 | Ford Escort Cars & Trucks

1 Answer

Just bought a used 1990 keep wrangler. The turn signal k arm on the steer wheel is missing. Is the windshield wiper control on the turn signal arm as well? I do not see a place to turn on the wipers


just get one from a junk yard to remove it just push turn and pull the only thing is that if the car has cruise control you got to cut the wire... and to install it your car push in and turn wiper will work signals but no cruise control unless you go trough steering coloum

May 01, 2012 | 1990 Jeep Wrangler

2 Answers

I have an 08 wrangler. The front windshield wipers won't turn off.


PROBLEM COULD BE FAULTY WIPER RELAY OR WIPER SWITCH.OR WIPER MOTOR LIMIT SWITCH.

Jan 14, 2011 | 2008 Jeep Wrangler

1 Answer

1989 Jeep Wrangler no power when key is in on position


Honestly, it sounds like a bad ignition coil. When they get corroded inside they will draw power on a scale much higher than anything else on the vehicle. It is a coil and it's job is to take a little power and make a lot of it. If it's only when the key is in the "run" position, that is likely the case. The only real difference between the two positions is that in the run position there is power being delivered to the ignition system. Good luck.

May 05, 2010 | 1989 Jeep Wrangler

2 Answers

Lights are on and won't go off, windshield wipers


any earthing point is open of wiring, check all earthing points, problem will solved.

Jan 24, 2010 | 2007 Jeep Wrangler Unlimited Rubicon 2...

1 Answer

Winshield Wipers stopped working on a 2001 Jeep Wrangler.


TAKE IT BACK THEY HAVE LEFT A LINK OR POWER FEED LOOSE

Dec 07, 2009 | Jeep Wrangler Cars & Trucks

1 Answer

I have a 1998 Jeep Wrangler and my windshield whipers, radio nor my turn signal are working.


I hate to state the obvious but you didnt say. have you checked your wiper relay and the fuses? Locted ubder the hood in a black box passenger side. Hope this helps.

Nov 11, 2009 | 1998 Jeep Wrangler

1 Answer

1998 Jeep Wrangler Electrical Short in Steering Column?


I had a similar problem with my 2000 Jeep TJ and I found the problem in the wiring harness under the hood.several wires were corroded and almost burnt off.If you remove the black tape which keeps the harness bundled together and if you see evidence of "green" type powder or "gook" it's most likely where the wires have faulted.

Dec 12, 2008 | 1988 Jeep Wrangler

Not finding what you are looking for?
2001 Jeep Wrangler Logo

Related Topics:

178 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...