I need to know where to look for the blower motor resistor pack
SOURCE: 2002 Chevy Impala Blower resistor location
It is on the passenger side, you have to remove the black plastic kick plate, below the glove box, to expose it (held in place with 2 latches and 1 push pin). The resistor is in front of the blower motor ( sandwiched between the motor housing and the firewall) it is tricky to get to, i think when i changed mine i didnt replace all the screws as they were difficult to remove and even harder to replace. Good Luck, Mike
SOURCE: help with location and replacing blower motor resistor
depends on what year van..1996-2000,located in engine compartment just above right strut tower at firewall..2001-2007..located behind glove box
SOURCE: have to change blower motor resistor where is it located
Located behind glovebox. 2 screws and 2 plugs. very simple
SOURCE: where is the resistor for the blower motor located
It's under the dash on the passenger side, remove the panel on the bottom of the dash, and its behind the blower motor. Takes about 20 min to get the job done and the parts can be bought at Auto Zone and there's step by step instructions top get the job done, don't for get the new wire harness also to go with the resistor. There also common to go bad, due to the heat from the current flow makes them brittle.
Thank you for using fixya and good luck
609 views
Usually answered in minutes!
×