How do you remove the upstream O2 sensor on a 1997 Mercury Tracer? You can get an O2 sensor socket on it but there is no room to move a ratchet handle or breaker bar.
SOURCE: Does a broken timing belt permanently damage a Mercury Tracer
depends on the Engine in the car.
1.9L SOHC (SEFI on Valve Cover)engine, no, they are non-interferance engines, put a new timing belt on it and go.
1.8 DOHC engine, yes, it will destroy the valves, head, pistons, and if really bad, the block too. These engines are interferance engines, where the valves just barely miss the piston as it comes up, and when the belt breaks it will hit the valves and destroy the engine.
SOURCE: serpentine belt for 1998 mercury tracer
Hey there MSM,
Mike
SOURCE: where is ecm box located on 99 tracer mercury
It is located under the dash, directly in front of the center floor console. The easiest way to access is to remove the console, which is very easy to figure out and do. The console is only held in place with about 6 phillips head screws
SOURCE: Light bulb number 1992 Tracer
The bulb number is A12V10W (12 Volts, 10 Watts). The easiest thing to do is to visit an automotive parts store as they usually have a bulb replacement manual which will list most of the bulbs based on the make, model, and year of your vehicle. The other alternative is to visit the link below and input the aforementioned data (I am not sure if the number that you will find on the website will be universal or only a Sylvania part number) http://www.sylvania.com/ConsumerProducts/AutomotiveLighting/LampReplacementGuide/
SOURCE: o2 sensors on a 99 mercury cougar v6
Should be 4. One in front of the catalytic converter and one after on both front and rear exhaust.
534 views
Usually answered in minutes!
×