2001 VW Golf GTi VR6
On the MAF sensor connecting plug you will see 5 pin numbers. Each pin number correspond to a wire color:
Pin no.# 1 = violet/green, is comming from pin no.# 26 of ECM. ECM = Engine Control Module.
Pin no.# 2 = blue/yellow, is comming from fuse no.# 43 = 10 Amp. (battery plus is comming through a blue wire from pin no.# 23 of fuel pump relay).
Pin no.# 3 = green, is comming from pin no.# 27 of ECM.
Pin no.# 4 = red/violet, is comming from pin no.# 53 of ECM.
Pin no.# 5 = black, is comming from pin no.# 29 of ECM.
Wiring diagram:
SOURCE: 2001 VW GTI VR6 alarm goes off randomly... make it
could possibly be a faulty latch. door latch, trunk latch, hood latch. something sporadically not recognizing a closed latch to cause it to go off sporadically. a scan with a vw scan tool or a vag com should detect a fault in the convenience system.
SOURCE: I want to put turbo to my Golf GTI VR6 98'
the amount of money and time it would require to turn your N/A (naturally aspirated) into a forced induction car(turbocharger, or supercharger), you would require the buttom end to be built, fueling, exahust, ecu(computer) forged rods/pistons/ then the turbo or super charger, also alot more, if you go to vwvortex.com and click on the forums and look around, you can see the different setups people are running on their VW's AUDI's
SOURCE: i need a wiring diagram for a 96 vw golf gti vr6
http://www.the12volt.com/installbay/alarmdetail/2180.html
SOURCE: Oxygen sensor for vw golf gti 1.8T 2001
There is four wires-two of them is white for the heater and another two is grey and black for the sensor.Zirconia or titania doesn.t matter.
SOURCE: Hello I have the emission workshop light on my vw
that is engine management light.you need a diagnostic test
2,630 views
Usually answered in minutes!
×