I bought a 94 Jeep Wrangler that did not have a rear seat. I have since purchased a seat and seat belts. The directions with the seat belts were not very helpful. Does anyone have an illustration as to where everything will mount or better instructions?
Your jeep should have all the holes and thread nuts already installed. pull up the carpet and locate them. the two close to the center are for seat belts as are the two outside of them. the four holes that form a large square/rectangular area are for the seat. if your seat is fold and tumble type, holes on the left wheel well are for the locking mechanism. i just pulled mine out and filled the thread holes with new bolts to keep out the water and dirt. yours may have screws or plugs in them. this install is for factory type only. mike
1,044 views
Usually answered in minutes!
no light in cluster
×