I have a 1994 camaro z28 and the fuel pump went out. in the manual it says to drop the rear end and driveshaft . can i cut a hole in my body and if so can you give me any clue where?...
I wouldnt cut a hole cuz the tank is about an inch away from your body . It is possible cuz my buddy did it to his 91 TBI really slow camaro . He made a door and had to cut his metal fuel lines and use hose clamps and rubber fuel lines to put it back together . It wont work on a 4th gen unless you cut a huge hole . Its a total barefoot redneck way to do it . Ive changed 4 in my 3rd gen (autozone pumps) back in the day and 3 in my 4th gen . Its not a easy task but you will spend as much time trying to cut a hole and fish your high pressure lines out of the way and fishing the whole sending unit out of your fabricated hole not to mention its a unibody and doesnt need holes in it or GM woulda put a door in from the factory . Drop your muffler all your suspension and the two 18mm bolts from your rear control arms and drop the rearend . Everything is out of the way then its 2 15mm bolts to loosen your tank straps and pop off your fuel lines which are plastic on a 4th gen and metal on a 3rd , and your there . Pop your retainer ring change the pickup screen (sock) when you change the pump then reverse the process . It usually takes 4 or 5 hours of hardcore wrenching but it gets easy after you change a few .The exhaust was the hardest to get off for me working off jackstands with a basic tool set . Lol cut it all off and replace it with a flowmaster cat back , its way easier and you will love the sound especially with headers . Its your car but im sure that most everyone who knows how to wrench , especially f bodys like myself will agree with me . Ive had both my cars tore apart and my 96 TA is gettting a 500 horse lt1 built for it as we speak . Its sat for 3 years so ill have to change my pump again no doubt . Oh buy a good bran name pump like an original Ac Delco or a good aftermarket one from summitt
Yes you can. it is near the center, a little to the left, start with a drill and drill a little hole so you can make sure your near it. but i dont suggest cutting it out.
I cut a 8x6 hole and made a stainless steel door with hinges and a gasket it looks nice
9,416 views
Usually answered in minutes!
why dont i want to cut a hole?... i would have to cut a hole big enogh to get out the old and put the new in... and also would i use a roto zip to cut the metal?
red light on rev counter of 1994 chev camaro z28
right behind the rear seat
×