Map sensor pin arrangement dodge cavan 2003

Here is a color diagram of the distributor plug for a 1997 Nissan Sentra GA16DE:
Pin 1: Black/White wire - Ignition pulse signal Pin 2: Green/Red wire - Ignition coil power Pin 3: Black/Yellow wire - Ground Pin 4: Blue/Yellow wire - Engine speed sensor signal Pin 5: Yellow wire - Power supply Pin 6: Green/White wire - Ignition coil signal Pin 7: Red wire - Power supply
Please note that wire colors may vary depending on the specific vehicle and wiring harness. It's always recommended to double-check with a wiring diagram or a professional mechanic before making any electrical connections.

The two best sites

1998 Dodge Ram Pickup Car Stereo Wire Colors and Locations

https://www.the12volt.com > installbay > stereodetail
1998 Dodge Ram Pickup Stereo Wiring ; Right Front (-), Dark Blue/Red ; Rear Speakers, 5 1/4" Side Panels ; Left Rear (+), Brown/Yellow ; Left Rear (-), Brown/Light ...

1998 Dodge Ram 1500 Radio Wiring Chart - MODIFIEDLIFE

https://www.modifiedlife.com > 1998-dodge-ram-1500...
Our 1998 Dodge Ram 1500 radio wiring diagram shows you all the radio wire colors and what they do. Table of Contents. 1998 Dodge Ram 1500 Radio Wiring Diagram ...

Pin 1 - Signal (Green/Yellow) Pin 2 - Signal Return (Grey/Red) Pin 3 - Signal (Orange/Red) Pin 4 - +5V Reference (Orange/Yellow) Pin 5 - Ground (Black) Pin 6 - Not Used

2001 Dodge Ram 1500 Radio Wire Colors
Car Radio Battery Constant 12v+ Wire: Red
Car Radio Accessory Switched 12v+ Wire: Red/White
Car Radio Ground Wire: Black/Dark Green
Car Stereo Dimmer Wire: Orange/White
Car Stereo Antenna Trigger Wire: Yellow
Left Front Speaker Positive Wire (+): Dark Green
Left Front Speaker Negative Wire (-): Brown/Red
Right Front Speaker Positive Wire (+): Violet
Right Front Speaker Negative Wire (-): Dark Blue/Red
Left Rear Speaker Positive Wire (+): Brown/Yellow
Left Rear Speaker Negative Wire (-): Brown/Light Blue
Right Rear Speaker Positive Wire (+): Dark Blue/White
Right Rear Speaker Negative Wire (-): Dark Blue/Orange

2001 VW Golf GTi VR6
On the MAF sensor connecting plug you will see 5 pin numbers. Each pin number correspond to a wire color:
Pin no.# 1 = violet/green, is comming from pin no.# 26 of ECM. ECM = Engine Control Module.
Pin no.# 2 = blue/yellow, is comming from fuse no.# 43 = 10 Amp. (battery plus is comming through a blue wire from pin no.# 23 of fuel pump relay).
Pin no.# 3 = green, is comming from pin no.# 27 of ECM.
Pin no.# 4 = red/violet, is comming from pin no.# 53 of ECM.
Pin no.# 5 = black, is comming from pin no.# 29 of ECM.

Wiring diagram:

Hello! There are two sensors that will cause this problem both can be tested...If you have a volt meter...If not, let me know...
#1 is the Throttle Positioning Sensor (TPS)...A black round device that is bolted to the throttle body with a three wire connector...Wire colors are...Gray/White...Brown/White...And Gray/Red...Using two safety pins plug them into the rear of the in place connector on the Gray/White...And Brown/White...Place + probe of meter set to read 5 volts on the Gray/White...And - probe on Brown/White...Start engine...At idle must read less than 1 volt (.85)...As you slowly increase throttle meter must rise smoothly to 4 volts at open throttle...If voltage jumps or acts erratic the sensor is defective...

#2 is the Manifold Absolute Pressure (MAP) sensor...Also mounted to throttle body...Three wire connector with the following wire colors...Light Green/Blue...Gray/Red...And Brown/White...Using the same technique...Pin the rear of the connector on the Light Green/Blue...And the Brown/White...Place + probe on Light Green/Blue and - probe on Brown/White...Turn key to on (don't start)...Record reading...Move Light Green/Blue probe with safety pin and push it into the Gray/Red wire...Record reading....Also check the vacuum line which is connected to the Map Send results...

Cost...TPS=$55............MAP=$95

Guru.................Saailer

I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867

7 pin standard codes: Blue Brakes, Black 12v power, white ground, red right turn, brown left turn, green marking lights, yellow accessory power. 4 pin standard codes: White ground, brown marking lights, yellow left turn, green right turn. These will only work if both were wired to the standard code.

glad you posted what colors you do have , cause 2 resources didn't match ,actually 3 , i did find a match to your colors was a 97 year model premium radio, so we have a match .....

black/ light green = ground
dark green = left front spkr +
purple = right front spkr +
blue/white = right rear spkr -
brown/blue = left rear spkr -
brown/yellow = left rear spkr +
blue/orange = right rear spkr +
black/yellow = park lamps
brown/red = left front spkr -
orange = dimmer signal
pink = fused battery +
green/red = radio choke relay
red/white = fused ignition
blue/red = right front spkr -

cheers

djmac62 is also an excellent answer

there is a code for color!? ok, wait im searching...
found it! here you go, hope it helps...

Wiring color codes are the identification colors that color the wires in your automobile. For example, if you have a British car the blue, blue and white , and blue and red wires are for the headlights. The red and white wires are for the instrument lights, and the green and white and green and red wires are for the turn lights. The color code simply identifies what that wire does. Could you imagine if all of the wires were the same color. You couldn't identify anything in a harness.