I've had all 4 windows fail and my driver door window is almost fully open. At this point, I'm just trying to get my window closed, since it's the middle of December. I have removed the door panel but I still can't see how to disengage the window from the regulator or how to have the motor cycle manually- in either case, to allow me to close the wondow.
SOURCE: Driver's side window stuck open.
unfortuanately the window has come off the track... happens for various reasons... on my windstar the side rail spot weld broke so the rail/track came off... i had to take the bracket out ... drill out the spot weld and put it back together with a rivet ... put the window back and it's been good since.... basically you will need to take the door panel off to see why it came off the track.
Robert
SOURCE: driver's door control panel doesn't work when door is open
Hi my name is Allen!
There is a ground wire that breaks between the door and the body, its inside of the rubber protector. If you peel the rubber from the door side you will find the ground wire broken.
NOTE: do not try to repair the wire at the break, because it will break again because of it bending at that location.
REPAIR: remove the kick panel trim and run a new wire from the inside out to the break, this will repair it for a long time. You must solder and heatshrink the wires together to keep moisture out of the repairs.
For further assistance contact me at FixYa!
SOURCE: driver side door showing open when fully closed
U need to replace the switch called a door ajar switch, it is defective and causing this problem, it is located in the front of the door opening it has a punger that moves in and out as door is open and closed. Here is a photo
SOURCE: RR window on my 02 Lib fell and now that door won't open!
As a last resort, I might try something like that, but remember that the door is heavy and that hanging it from the latch assembly will not do good things to the latch. If you try that, I'd first open the window and tie the door off to the roof rack to keep the door weight off the latch. Likely the latch will not release by removing the hinge bolts, but it may give you more room to get the inside panel removed.
SOURCE: 1999 Jeep Cherokee Sport How do you
I WOULD CHECK THE WIRING BETWEEN THE DRIVER'S DOOR AND THE POST..YOU WILL SEE A RUBBER BOOT BETWEEN DOOR POST AND DOOR..HAVE SEEN PARTIALLY BROKEN WIRES CAUSE ALL SORTS OF PROBLEMS HERE
116 views
Usually answered in minutes!
×