I also have that same vehicle but, I'm sorry to say it does not have cruise. I also have a wiring issue. I replaced the interior (seats, carpet, door panels, and a few dash moldings) with duel power seats, however I through out the old seats before I noted the "wiring colors" for the passenger seat 'seatbelt' and 'airbag' sensor connections. The new seats came out of a 2003 crown vic (not a p71) and had totally different connections under the passenger seat. My '05 p71 did not even have the wires there for a power passenger seat, so I had to replace and wire them in from the harness that I removed from donor car. That actually wasn't TOO bad, and the seats work fine, but I don't know which wires go together for the seatbelt and airbag sensors, as the old wire 'colors' under the seat do not match the 'colors' on the connectors under the new power passenger seat. If you could tell me the colors of the wires to your original seat (passenger), for the seatbelt and airbag plugs you would be a great help in solving my issue with the "airbag" and "seatbelt" light that stays lit on the dash. If I can help with your problem in some way, even though my car does not have cruise, e-mail me and let me know how ([email protected]) .
SOURCE: fuse diagram for 2000 crown victoria
there are 5+ pages of fuses what specifically do you need
SOURCE: 2005 crown victoria police interceptor headlights problem
Look up LCM on ebay. There is a guy in Wisconsin who will rebuild it for $45.00. 24hr turnaround, lifetime warranty
SOURCE: 2006 crown victoria - no heat
I would change the thermostat in the vehicle first and go from there. Hope this helps......Dan
SOURCE: Headlights turn off while driving
Headlight module under the dash. It is the size of a box of crackers, not a small part.
SOURCE: cylinder 4 misfire on a 2000 crown victoria interceptor
first cylinder 4 is the last on the passenger side . first pull the coil out and check if there is water where the plug is. if there is take the water out and dry up the coil. if you find water you got a crack manifold or a bad intake manifold gasket. if there is no water replace the coil. good luck
764 views
Usually answered in minutes!
×