SOURCE: How to change alternator on 2005 Jeep Wrangler
Straight out of the repair manual:
REMOVAL
WARNING: DISCONNECT NEGATIVE CABLE FROM BATTERY BEFORE REMOVING BATTERY OUTPUT WIRE (B+ WIRE) FROM GENERATOR. FAILURE TO DO SO CAN RESULT IN INJURY OR DAMAGE TO
ELECTRICAL SYSTEM.
(1) Disconnect negative battery cable at battery.
(2) Remove generator drive belt. Refer to 7, Cooling System for procedure.
(3) Remove generator pivot and mounting bolts/nut (Fig. 2) , or (Fig. 3). Position generator for access to wire connectors.
(4) If equipped, unsnap plastic cover from B+ terminal.
(5) Remove B+ cable output terminal mounting
nut at rear of generator (Fig. 4), (Fig. 5), or (Fig. 6). Disconnect terminal from generator.
(6) Disconnect field wire connector at rear of generator by pushing on connector tab.
(7) Remove generator from vehicle.
INSTALLATION
(1) Position generator to engine and snap field
wire connector into rear of generator.
(2) Install B+ terminal to generator mounting
stud. Tighten mounting nut. Refer to Torque Specifications.
(3) If equipped, snap plastic cover to B+ terminal.
(4) Install generator mounting fasteners and
tighten. Refer to Torque Specifications.
CAUTION: Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.
SOURCE: how do i change the belt on my 2005 jeep wrangler?
under the hood if you look carefully one of the pulleys is spring loaded and there is a square hole it, u put 3/8 ratchet in hole and pry away from belt to loosen take off belt and care fully look at where it runs and put new one in same way last u pry pulley again and put belt over tension pulley last. another choice is ask at parts store and they will likely show you pulley and if u purchase a chiltons repair manual for your cars for around $25 it covers most basic repairs and has steps and diagrams to help you fix many things great book to have
SOURCE: how to change transmission fluid in 2005 jeep
Most have a drain plug on the pan. to do a simple change, just remove the plug and drain it, then re-fill. to do a filter change, you need to remove the pan and the filter inside, remove all the gasket material (or it will leak) and put everything back together. There is no provision for draining the converter so if you want to do a better more complete change, drain from plug, refill, drive a few miles to circulate new fluid, then do a complete change with filter. You won't get it all out but a considerably larger portion of the old fluid will be removed.
SOURCE: 2005 Jeep Wrangler Unlimited cruise control will not engage.
check the vacuum line on the right side of the engine. There should be an elbow connector connecting the line to the engine. Does interior fan only come out of the defroster vents by chance?
534 views
Usually answered in minutes!
×