I have a '98 Jeep wrangler....when I turn on my hazard lights the left side flashes fast both dash and outside indicators light up....the Right side does not light up either on the outside or dash indicators.
I have a 1997 Wrangler with the same problem. The left flashers cycle at twice the speed, and the right side does nothing. The bulbs all seem to be working because my turning indicators are fine. I have a 1997 Wrangler with the same problem. The left flashers cycle at twice the speed, and the right side does nothing. The bulbs all seem to be working because my turning indicators are fine.
You can't post conmments that contain an email address.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Only the bulb is linked with those seperate items the bulb runs both blinker and hazard normally one goes both go when u have tufrn signal on inside if u hear it flashing fast its ur bulb
That is how it tells you that there is a bad bulb in your left side turn signal. Best way to check them is to turn on your hazards look at the front to see if there is one flashing on the right that is not on the left, then do the same with the back. You should see a bulb not working in the left .
Are you sure the right side bulbs all flash? You say you replaced all the bulbs? Why would you replace bulbs that were working? Did you have this problem before you replaced the bulbs, or after. The hazard flasher is down under the dash, left side, turn the signals on and follow the clicking noise.The hazard flasher and the turn signal flasher should be near each other, and are interchangeable. If it clicks fast, a bulb or a bad socket is usually the cause. These trucks have a lot of problems with the tail light circuit boards.
Probably a bad ground on your front right signal, or a bad bulb. Try switching the right with the left, and see if the problem stays in the same place, or goes with the bulb.
I have a 1997 Wrangler with the same problem. The left flashers cycle at twice the speed, and the right side does nothing. The bulbs all seem to be working because my turning indicators are fine.
×