Front stabilizer mountings for Honda Accord 2003-2004

Front caliper to carrier= 37 ft lbs
rear caliper to carrier= 17 ftlbs.
Found this info in my database.

1994-1997 Honda Accord Rear Motor Mount - YouTube

? 13:31
https://www.youtube.com/watch?v=QTDLBZonjvo
Aug 14, 2014 - Uploaded by NutzAboutBolts
1996 Honda Accord rear engine mount Tools: Impact wrench 3/8 ratchet ... Wat size are those bolts in the rear motor mount, I have to replace them ..... 1998-2002 Honda Accord 3.0 V6 Spark Plug Replacement - Duration: ...

How to Replace the Motor Mount on a Honda Accord ...

? 5:28
https://www.youtube.com/watch?v=jCIBNq0jg0U
Oct 17, 2013 - Uploaded by Chandler Cox
How to Replace the Motor Mount on a Honda Accord .... I have 2001 Accord and engine/front vibrates when car is idle. .... onreplacing and removing rear mounts for this year and model car.... 1998-2002 Honda Accord 3.0 V6 Spark Plug Replacement - Duration: 12:48. by CharlietoKind 103,467 views.

How To Change A Motor Mount and Transmission Mount ...

? 29:43
https://www.youtube.com/watch?v=vkO19Ux9q9M
May 30, 2013 - Uploaded by klowny1969
Step by step honda transmission motor mount and transmission... 2000 2001 2002 2003 2004 2005 engine mount how to replace install check change ... MAKE A VIDEO TO INSTALL THEREAR MOUNT MOTOR PLEASE .

For 1992 Honda Accord 2.2L FI 4cyl the Oxygen Sensor is located:
DX, LX model
Under hood, center, front engine area, mounted in exhaust manifold

EX model
Under hood, center, lower engine area, driver side rear of engine, mounted in exhaust pipe

Hope helps (remember to rate this answer).

Are you sure you have the correct code? Look in the glove-box. There should be a small sticker, usually near the front left of of the compartment. There will be two sets of numbers. The number set with 5 digits is the correct code.

If you or someone else changed the radio, you'll have to contact the radio manufacturer with the radio model and serial numbers for the code.

Typically this a result of bad motor mounts, I had the same issue with my 92 honda accord, changing the side mounts and the strut up front resolved the issue. The Trans mount, behind the motor is the most difficult mount to change and requires you to unbolt the other mounts and roll the motor far enough forward to gain access to that mount, but once all 4 mounts are replaced your issue should be resolved

You have to call a dealer and get the phone # for Honda to unlock. Then need to pull the radi and give them the # that is on top or bottom of the radio and they will give you a master code to enter and unlock.

have you taken alook at your front susupenssion see if the sway bar has good rubber

OBD DIAGNOSTIC LINK CONNECTOR / 1995 Honda Accord 2.2L MFI 4cyl
The OBD Diagnostic Link Connector is located: Front seating area, driver side, driver side of steering column, mounted behind center of instrument panel.

Good luck, and remember rated this help.

look carefully at the front engine mount and the rear engine mount...the front dogbone looking mount usually crack or break ...ur rear mount may also be broken and or worn...

If it's not your strut mounts i would check lower and upper ball joints hope this help if you have any more que. i can help you  just ask