I have a 93 jeep wrangler yj when i turn on the left turn signal it makes both reverse lights flash also

the fsm 94 wrangler.
we have a free book, 93 YJ
see chapter, 8E-1 ? instrument...... (words only)
then chapter,wiring, (last is list)
see that? see pdf page, 55? index then on to instruments yj
page 44 real. PDF page 110. BINGO.
the it is.
http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service

or alldata.com
or any real FSM from jeep.

3 choices. always.

alldata.com

or
93 yj
might work?

http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service

or get the operators guide, missing from glove box.
it covers fuses.
and Rev back fuse is marked on cover
as is TAIL (park and dash.)

ah.
how to reassemble the 93 jeep wrangler steering column?
someone else took it a part?
read the FSM. free.
YJ JEEP
http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service

You have burned fuse 9 in the interior panel. Is that the one you replaced?

How do I get to the windshield wiper motor on a 1990 Jeep Wrangler?

I would really try to get the same year and motor as you have. There is some much that often changes from year to year, and engine to engine.

This problem is usually caused when the switch in the gearbox siezes. It is easy to replace as you can get to it from underneath the car. Once you have found it, switch the ignition on but engine not running, and check that the reverse lights are off, push a bent paperclip into the end of each wire to make a circuit and the lights should be on. Your local spares shop will have a replacement.

sounds like you are working on a car FSM free?
why do that?
95 YJ
early wrangler
i have 95 yj fsm and 93, the 93-95 are a year class range.
very simular.
here is a free 93 fsm with full schematics in chapter 8w
wiring chapter, clik
pdf 76 is page YJ 19 actual
and as you can see its cave man simple 2 wires.
minus to ECU ignitor driver. transistor (inside ecu)
and
+ goes to
a142 sheet 5 (pdf 62)

im not sure what part A<B<C is, a fuseable link, is my guess
and is blown. but that be a bingo spot for sure.
the full manual is there.
see spark chapter.
http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service

posted over 100 times, this link, its not new.

Probably a bad ground on your front right signal, or a bad bulb. Try switching the right with the left, and see if the problem stays in the same place, or goes with the bulb.

Our Jeep Wrangler YJ's are equipped with a vacuum module on the front axle. It is used to engage the front axle when the transfercase is shifted into 4WD. Check the vacuum lines on the front axle to make sure they are connected. The passenger side axle shaft has a disconnect sleeve that is moved left and right by the vacuum.