Could be your clutch slave cylinder is bad,check your clutch fluid,if real low or empty then it is bad,it's located on the side of the transmission with a hydraulic hose connected to it,I have a 85 Nissan 720 4x4 5- speed,had to replace mine a few times.Here's a link on how to do. Repair Guides Clutch Clutch Release Cylinder AutoZone com Here's another link. Repair Guides Clutch Clutch Master Cylinder AutoZone com Here's the new part. Duralast Clutch Slave Cylinder 12425 Read Reviews on Duralast 12425 Your master cylinder probably is good,I just had to change the slave cylinder on mine,unless your's is leaking.If you are in a bind you can add brake fluid,yes it uses brake fluid.Then bleed it then it will get you home,you can get a one man bleeder kit,I have one,here it is. OEM One man brake bleeder kit 25036 Read 17 Reviews on OEM 25036
Hi Jeremy.I forgot the part on how to bleed your hydraulic systemhttp://www.autozone.com/repairinfo/repai...
×
SOURCE: 1995 Nissan XE Pickup Transmission Problems-PLEASE HELP
your luck as with mine is not good. thought I had a bad bearing, after droping the tranny and seperating the housing, I have a broken counter shaft. after looking for another with no luck, the tranny shop informed me that was common for these transmissions. parts are expensive, to rebuild would cost aprox.$800.00 or more. the main cause is the front bearing is supported in alum. causing shaft to move which first takes out the bearing, then the strain snaps the shaft. taking out all gears except 4th and only moves while in 4 wheel drive.
SOURCE: 99 nissan pathfinder 4 wheel drive once put into 4 wheel drive popping noise underneath the vehicle
that sounds like a bad universal joint on the transfer case to the front axle. have that checked out
SOURCE: Car won't go into gear properly
it could be a few things bent shifting fork or first gear is out reverse runs off an idler that is conected to first gear.
367 views
Usually answered in minutes!
×