Question about 2000 Dodge Intrepid

1 Answer

Just changed timing chain on 1999 intrepid, when i started engine it revs to 4000 rpm and stays their. checked gas pedal, cruise control and throttle body. all seem to be fine

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 4 Answers

Check for a vacuum leak, possibly an electrical component is not plugged in correctly or plugged into the wrong device (idle air control, throttle position sensor, egr solenoid)

Posted on Aug 29, 2011

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 intrepid engine surge at 4000 rpm at neytral and park.?


Be careful, could be dangerous, and similar to the Toyota problems before. Gas pedal and or linkage sticking? Last time serviced?

Feb 28, 2015 | Cars & Trucks

1 Answer

High idle close to 4000 rpm


seen as there has been a leak in the coolant system in the heater core it is possible that the coolant system has a air lock in it and a few things can resolve this. fill the coolant system to the correct level just with water until the problem is rectified. most vehicles have a air bleed screw. with the engine run up to normal temp and the pressure cap on bleed the air out of the coolant system by undoing the screw a few turns and releasing the air from the coolant system, if fitted with a bleed valve it will be some where on the higher part of the coolant system. if not fitted with one it can also be done by raising the front of the vehicle in the air by a trolley jack and using a coolant pressure tester on the coolant system , compressing the air and moving it along to the radiator . then when the compression tester is moved off the system top up the rad and reserve to the correct level and see if this helps . also it is possible that the thermostat may have been damaged and isn't working properly. check the throttle cable for being kinked , jammed or faulty return spring , also check full throttle travel at the butterfly and that it is returning to the closed position. next up would be clean the throttle body as well as the iac (idle control circuit) these get gummed up from time to time and can cause a issue as well. other possibles are a vaccume leak . hope this is of some help mate. 25308008-fpzkrwmvbajwh1n4vjb0ch5c-1-0.jpg

Dec 04, 2014 | 2000 Isuzu Rodeo

1 Answer

Why is it that my kia 2002 sportage automatic is experiencing dead acceleration/throttle even if i push pedal


throttle position sensor/ Idle air control sensor no good one or both could be bad if you are parked can you press on the gas and the engine raises the rpm's or does it stay the same could also be accelerator cable broke if no raise in engine rpm's revs up

Aug 23, 2014 | Cars & Trucks

1 Answer

2006 aveo throttle body issues


What engine does it have ? Could have come with 5 different ones . If it has the 1.6 L engine . has electronic throttle control.
The throttle actuator control (TAC) system is used to improve emissions, fuel economy, and driveability. The TAC system eliminates the mechanical link between the accelerator pedal and the throttle plate. The TAC system eliminates the need for a cruise control module and idle air control motor. The following is a list of TAC system components:
• The accelerator pedal assembly includes the following components:
- The accelerator pedal
- The accelerator pedal position (APP) sensor 1
- The APP sensor 2
• The throttle body assembly includes the following components:
- The throttle position (TP) sensor 1
- The TP sensor 2
- The throttle actuator motor
- The throttle plate
• The engine control module (ECM

Check engine light lit ?

Aug 26, 2017 | 2006 Chevrolet Aveo

1 Answer

Throttle position sensor problems


reduced engine power has to do with the electronic throttle control or drive by wire . All electronic wires under the dash on the gas pedal , electric motor on the throttle body . DTC'S - diagnostic trouble codes stored in the computer . Take it to the dealer .

Mar 04, 2017 | 2002 Chevrolet TrailBlazer

1 Answer

My 05 pt cruiser engine revs up to 4000 rpm when I start it then it drops down and stauls


runs some good fuel cleaner through your tank to clean out gumming deposits and also get some throttle body cleaner and clean out throttle body.. Chevron tech is best cleaner out there .. When cleaning throthle out run engine and manually operate the gas pedal in engine area and open butterfly up and clean the gum off it as it will cause rpm to surge if not cleaned

Aug 25, 2013 | Cars & Trucks

1 Answer

My 2003 neon stalls as soon as I take my foot off of the accelerator pedal or slow down it just dies....i put it in neutral and rev the engine and it revs to 4000 rpm and just breaks up....i just changed...


you may have a dirty fuel filter or the throttle plate may need cleaning.the throttle plate is the valve that moves in the intake when you move the gas pedal.if they get too dirty they cause a restriction in the intake and cause the car to stall.it also could be a tps sensor problem but this should put the check engine light on but not always.the breaking up of the motor when you rev it to 4000 rpm`s is the rev limiter in the computer that shuts down the firing of the plugs and injecotrs so you don`t cause damage to the motor when there is no load on it.

Sep 17, 2011 | 2003 Dodge Neon

1 Answer

My f150 4.6 stugles to stay on after i start it however if i keep my foot on the throtle long enough the engine comes alive with no knocking or smoke but when i remove my foot off it chockes with very low...


you might try cleaning the throttle body first. Buy some good Throttle body cleaner and a old tooth brush take off the air intake hose to the engine, have a friend hold the gas pedal to the floor with the engine off and spray and scrub the throttle body good replace the tube crank it up and rev it up a little to clear out the cleaner this may fix your problem

May 08, 2011 | Ford F-150 Cars & Trucks

1 Answer

Carburation & emission control?


check for broken or disconnected vacuum hose/line
also check for the fast idle sped control valve for defect

Mar 18, 2010 | 1983 Honda Accord

Not finding what you are looking for?
2000 Dodge Intrepid Logo

182 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...