Localitation map sensor ranger 4.0 1993 - 1993 Ford Ranger SuperCab

code p 107 refers to manifold absolute pressure (MAP) sensor / barometric pressure(BARO) sensor --low input===causes ---wiring short to ground---MAP sensor---BARO sensor ---ECM

code p 0107 refers to manifold absolute pressure (MAP) sensor /barometric pressure (BARO) sensor --low input ====causes --wiring short to ground ---MAP sensor ---BARO sensor ---ECM
code p 2263 refers to turbo charger (TC) boost pressure /supercharger (SC) boost pressure ---performance problem====causes --mechanical fault
code p 2227 refers to BARO sensor -range / performance problem===causes wiring --- BARO sensor --- ECM
I would be testing the BARO sensor for a problem as it is listed for all 3 codes
if you don't have such a sensor you have a MAP sensor which is reading in the same area so test that as well

The fuel pressure regulator and the MAP sensor need to have there own lines. Everything else can be spliced together. Put the check valve to the recirculation valve.

Under hood, passenger side, rear engine area, mounted on upper firewall this is it

run fault codes and check for O2 sensor problem and MAP/MAF sensor problems. If it is misfiring then codes for injectors and plugs may also appear

Some of those models had a MAP Sensor and some didn't.The mazda and the Ford ranger are the exact same truck with the exception of the grill and tail lights. I am not sure if your saying that you have a map sensor and no wire or a wire and not map sensor.If there is no wire for a map sensor then you truck does not require one. If it has the wire then you will have to get a map sensor.The trucks that don't have a map sensor will have a Mass Air Flow Sensor, located at the top of the air filter box.
I hope this will help you.

Before you start pouring things in the gas tank check your map sensor or you o2 sensor

check the map sensor.

22 manifold absolute pressure (MAP) sensor circuit out of range
you have a hard fault for the MAP sensor, this means the MAP sensor is either disconnected or defective, replace it if it is connected.

check to see what codes are present. sounds like it is running rich check o2 sensors vacuum leaks map sensor.