20 Most Recent 2004 Toyota Camry - Page 4 Questions & Answers

flat battery in car and key sensor

How To Bleed Cooling System EricTheCarGuy

A faulty alternator won't set of battery light until it sucks your battery down below a certain voltage. Still sounds like an alternator. Get a volt meter and take a reading of battery while car is off. Should be around 12.5 v. Start the car and watch the meter to see what kind of drop the battery sustains under cranking conditions. If it drop below 9v battery may be suspect. With vehicle running alternator should produce 14.4v. If not, replace it.

left side dash under kick panel

if you are just changing a bulb I believe its a9005 or9006 hi or low beam if you oar taking lense out you have to the shield under bumper then the screws on inner fender where it attaches to front bumper then theres a 10 mm size bolt in corner of bumper that goes strait up into fender once that's out, pull on side of bumper. itll pop out theres clips that hold it on. then you can get to bolt on bottom of light,get that one and top ones and you can pull lense off. just smack bumper to put back on you only need to pull back side your changing

you mite want to go to another dealer it just should need to be recaibrated I drive a 05 and iv had to do mine before write the code its got and I can check Monday.

Replace the fuse with one the same rating. If the seat now works.... smile. If the new fuse blows or the heat does not work you may have a short (or a broken wire) inside the seat that's causing the problem. It's an 11 year old seat.... tearing it apart to find the source may not be worth it.

Some cars need capicters installer for hid,s to work properly If you need further help, reach me via phone at https://www.6ya.com/expert/scott_87482045335a4757

Deck Lid could be jammed or defective latch. Crawl through to trunk and see if pull latch releases it. Have someone lift on the trunk or push down outside while doing it. WD 40 could help or even better spray with white lithium grease spray. 4 or 5 dollars at auto store.

basicly is a filter to help reduce the emissions (pollution) if this part fail your car never going to pass the smog control test required for the state

Do you have a interior light dimmer/switch next to the head light switch? rotate it until interior light comes on,then back just enough to them off. Now turn on headlights; Can You see me now? Hope thats IT, Good Luck

i smash headlights out all day like this!

if u follow the large fexiable rubber air intake hose from the engine to a large plastic box/inclosure that is the air cleaner housing, the filter is inside.

Codes tell you where to look. But a scanner will tell you results. A throttle position code will tell me to look at the sensor at the fuel pedal. That's where it is at on some cars, usually newer. The way to tell the difference is that the throttle body on the engine will have a big control module/box on the side of it. The the TPS will be at the fuel pedal.

301 is cylinder #1could be bad coil or bad module.

i would be a problem with the little depress button on the door or on the door frame, what make the beep stop when key is in ignition and door open. it also make the internal light and the igniton light go so in dark can see key whole, hope this helps, just to note it may be any of the doors faulty depressor thing, they all have them,

USE A FUSE PULLER.SOUND LIKE YOU BROKE OFF FUSE TERMINALS WHEN YOU REMOVE THE FUSE.

if the signal light is not separate(different colour) from the brake lights then they are different bulbs. if they use the same bulb then it will not work either on brake or signal.

Fuses on door locks ,seats, and horn.

https://www.youtube.com/watch?v=BiW0ISi8N-w https://au.answers.yahoo.com/question/index?qid=20090328074257AAHgtbI http://www.ehow.com/how_4894305_struts-bad.html