20 Most Recent
1995 Toyota Camry - Page 2 Questions & Answers
95camryle driver's side door won't open.Trying to lock all doors with main switch, looking at all locks, they go to the lock position & then spring back to unlock position.
The best solution yo u'll get from books at
www.reliable-store.com
These are books containing info on repair, service, troubleshooting, parts info, assembling dissemble, removal, error/fault codes, wiring diagrams and everything on any vehicles cars, atv, trucks. forklifts, boats, excavators etc.
RPMs jump up while driving. Foot off accelerator
This type of problem needs to be approached with diligent process of elimination to properly diagnose.
Check for vacuum leaks...with the engine running, spray carb cleaner at each joint and seal along the intake system and intake plenum. If there is a leak the engine idle will change as the spray is taken in through the leak.
The idle air control valve could be faulty or dirty. Remove the idle air control valve and clean the interior with carb cleaner.
There could be deposits in the thottle body causing the throttle valve to stick open. Check for free operation of the throttle valve. Clean the throttley body with throttle body safe (NOT car cleaner) cleaner by removing the intake hose, spraying the cleaner on the paper towel and cleaning the interior of the throttle body while holding the throttle butterfly plate open.
Make sure the throttle cable moves freely and that the return spring is present and working properly.
To go beyond this may require special diagnostic tools.
I have a 93 Toyota
no spark crank sensor. good you getting fuel but with no signal from the crank sensor it will not fire up. can also be oil pressure switch so if the oil light wont go out while cranking the engine it can be this as well
How can i reset my airbag light on a 1995 camry
Should not have anything to do with the fact you did not disconnect the battery it sounds more like you have nocked an air bag sensor that may be on its way out.
The thing is they are to important to play with if you take to an auto electrician they can reset the computer.
Then if it comes on again you may need to spend some $
Let me know how you go.
Regards Craig
Power windows and door locks not working
replace the fuse,,, try operating the passenger window from the switch on the passenger door.. see if the fuse fails again...the rain wouldn't normally be a problem, these are designed to operate in wet conditions unless the thing was literally water logged.
95 camry won't start
If it is an old battery start with replacing that. If it then still won't start you would suspect the starter solenoid contacts, which are replaceable. The click indicates the solenoid is pulling in OK.
95 4cyl camry intermittant spark loss thus engine
Test the crankshatt position sensor. If it tests good, please get back to us.
OPERATION
The Crankshaft Position (CKP) sensor provides a signal through the ignition module which the ECM uses as a reference to calculate rpm and crankshaft position.
TESTING
The crankshaft sensor should be tested either cold 14-122°F (-10-50°C) or hot at 122-212°F (50-100°C).
- Using an ohmmeter, measure the resistance between terminals. Resistance cold should read 1630-2740 ohms and hot; 2060-3225 ohms.
- If resistance is not within specification, the sensor may be faulty.
REMOVAL & INSTALLATION
See Figure 1
Fig. Fig. 1: The crankshaft position sensor is located to the right of the water pump-1MZ-FE engine
- Disconnect the negative battery cable.
- Remove the right hand engine under cover.
- Remove the right side fender apron seal.
- Remove the sensor wiring retaining nuts.
- Remove the bolt and disconnect the crankshaft position sensor wiring, then withdraw the sensor.
To install:
- Install the sensor and secure with the bolt to 69 inch lbs. (8 Nm).
- Attach the engine wiring.
- Install the right hand fender apron seal.
- Install the right hand engine under cover.
- Connect the negative battery cable.
- Reset any electrical components such as the radio or clock.
1995 Camry tail/brake light
You should as a first step examine the wiring loom where it attaches to the trunk lid hinge. Camrys of that era became well known for fraying and breaking of the wiring in that spot. You may have a breakage or short circuit.
Not finding what you are looking for?