1989 Toyota Camry - Answered Questions & Fixed issues

Question edited for 'year make model'. Question moved to model category. Service manual. Snapshots are available via Google search, 'year make model (the part) diagram'. There is not enough information in your question to help. https://www.google.com/search?q=1989+toyota+camry+service+manual The Owner's Manual gives basic maintenance and is free! https://www.google.com/search?q=1989+toyota+camry+owner+manual Generic Engine Diagram https://www.google.com/search?q=1989+toyota+camry+engine+diagram+pdf ..

Just go to the dealership and order keys based on the VIN Number. Or a local locksmith can impression a key and cut you one freehand. You are making this a lot harder than it is. You need a key.

I'm in the process of searching for some wiring diagrams for my 89 Camry so I just happen to have my owner's manual next to me. I've scanned in the pages that contain the fuses and their locations.

use only the correct parts for this or fail you will, guessing does no work in electronics ever, (or engine or trans) so cant find it at rockauto first. always look there as they have deep support for sure relic cars, not seen on the road now,(rare) and deeper choice of all parts for this car, huge choices even top brand. (but this case, too rare) not sure me your question, at all, now to test electrics on cars or what/? as in using a voltmeter to find what is bad, check fuses first. 33 years old is not any kind of spring chicken,. car it is super old. means parts now hard to find, I'd sell it as a classic. me. my fav year for cars is 1996, (just one computer to make happy) USA answers all, no where else me. your car parts sellers all ask this first DLX All Trac; DLX Model; LE All Trac; LE Model; w/ Cruise Control try here first https://www.rockauto.com/en/catalog/toyota,1989,camry,2.0l+l4,1272899,electrical-switch+&+relay,turn+signal+relay,3904 even find it there then google it find it closer to secret country learn to google for sure and 10x that rare 33 year cars. or ask the toyota dealer for parts?, expect laughs or silence

You could try servicing the trans (change the oil and filter) dirty fluid can couse this kind of problem.

Have you checked cam timing?If it has jumped a tooth or two it will not start.

Its time to stop being afraid of the unknown. there is no doubt that you will need to remove the inner door panel to access the electrical modules behind the buttons. https://www.youtube.com/watch?v=p2_f7NkjH8E hope this helps.

Gas pedal is stuck on what can I do to unstick it?

due to electric short circuit some of the wire has damaged to locate the fault and to repair you need the wiring diagram along with repair manual to fix the problem to get the manual go to the given link and get the manual http://toolsnyou.com/

I think the overfilling indeed is causing some oil burning on startup when clearances are wider. Drain it down to the right level, by taking out the sump plug for a second or 2. You can do that with the engine cold, but use a dead clean catch container in case some oil has to go back in.

Hi Sounds like the ignition barrel has failed. If you replace any part you must ensure that the key and the transducer ring are matched. If not, the immobiliser will come on and you will never start the car. Get a diagnostic test to verify the immobiliser is turning off. Roger

SOUNDS LIKE AXLE WINDING UP. ARE YOUR TYRES ALL THE SAME SIZE AND ARE YOUR HUBS FREEING PROPERLY?

Check your pcv valve hose,could be leaking.

Probably the temperature sending unit...if not that the relays...they should be relatively cheap and easy to replace...

If it ran prior to removing the distributor, it maybe 180 degrees out. Remove the cap, leave the rotor in place, loosen the bolt and lift it up,turn rotor until it is on the opposite side and place it back in.

Try installing a jumper across the N/O terminal at the relay socket. Temp sensor in the radiator or in the thermostat housing supplies the signal for the relay the other relay signal is supplied by A/C in on position. both fans will run continuous with A/C on. One fan runs intermittent relative to water temp. Be careful not to blow a head gasket. If you leave the jumpers in place, the fans will stop when the ignition is turned off, save the engine until you isolate the relay signal problem. then simply remove jumpers and reinstall the relays

The manual crank has a u shaped clip that holds it in place to the crank pulley. U may need a special tool to open the clip and slide it off so you can remove the handle.

It sounds to me not enough fuel getting to engine.could be a fuel pressure problem.Maybe a faulty fuel pump.or could also be a faulty idle sensor.Just a few possibilities Good Luck :)

Red is positive, black is neg. Yellow is alt 12 volt (turns in with the key). Blue is power to amp or power antenna. And the double colored ones are to each speaker

Hello anonymouse, RockAuto says... "electric sensor" 1989 TOYOTA CAMRY 2 5L V6 Speed Sensor RockAuto