20 Most Recent
1989 Toyota Camry - Page 2 Questions & Answers
AC and Cooling Fans Not Working
Try installing a jumper across the N/O terminal at the relay socket. Temp sensor in the radiator or in the thermostat housing supplies the signal for the relay the other relay signal is supplied by A/C in on position. both fans will run continuous with A/C on. One fan runs intermittent relative to water temp. Be careful not to blow a head gasket. If you leave the jumpers in place, the fans will stop when the ignition is turned off, save the engine until you isolate the relay signal problem. then simply remove jumpers and reinstall the relays
How to remove ignition without keys
if you have a metal bit for your drill that's small enough to drill a hole into the middle of the key:
drill a hole into the center of they key. stick in something into the hole (preferably a rod of metal) with superglue on it and gently try to turn the ignition after it's properly dried.
My brake lights don't come on but brakes do work. hoq can I fix it?
Check fuse first. If ok the brake light switch maybe defective, its under the dash connected where your brake pedal mounts. should be a two wire switch. You can jump the wires to each other if brake lights light switch is defective. Also make sure that when you step on brakes that the plunger on the switch is being fully released. Sometimes its the adjustment not letting them work. Good luck.
Not finding what you are looking for?