20 Most Recent
2007 Toyota Yaris - Page 2 Questions & Answers
2007 Yaris daytime running lights not working
assuming your head lights are working otherwise. I would check your DRL relay circuit. check your fuses (ecu-b & ecu-ig) are for daytime running lights. then you'll have to do a bunch of voltages checks to make sure its not the harness or a connector which I can get for you. and if everything checks out only thing left is the relay assembly..
When I first start my 2007 Toyota Yaris, it makes
2007 its your drive belt,let the dealer inspect for wear or if its loose,they are not going to reproduce it they are just sending you air, but hold them accountable for the drive belt and just ask ,"hey is this belt okay and I am not going to breakdown".
How much ac oil in Toyota Yaris?
1 Are you recharging yourself?
2 Have you removed any previously installed components like compressor, condenser etc
In the case you are replacing any of the components you should get the oil from the parts store or it usually comes with a new compressor. I think it is about 120 CC but in case you are just changing the compressor the rule of thumb is to drain the oil out of the old compressor in to a measurable container and replace with the same amount in the new compressor. attached is a chart if any of the components have been changed and how much oil might be needed.
Torque settings on a yaris 1.3 16v big ends,mains,flywheel,cylinderhead
Toyota Yaris Main and Big end Torque settings:
Tighten the main and big end bolts in sequential order and in two steps.
Main bearings. Stage 1.
22 ft lbs.
Stage 2.
44 ft lbs
Big end bearings.
Stage 1.
11 ft lbs.
Then Rotate bolt head a further by 90 degrees
Head bolt torque must be done in 3 steps:
1st 22 ft lbs
2nd 43 ft lbs
final 47 ft lbs
use this sequence of tightening:
9 - 3 -1 -6 -8
7 - 5 - 2 -4 - 10
Flywheel spec:
65 ft lbs
After a minor rear end bump on my Toyota Yaris
The hit may have closed a body drain. If it did this then you would have rain water collecting until it spills over. Look in that area for a plugged or crushed drain hole. That may help. Otherwise you may have to take it to a body shop to have the dent pulled.
Engine check light with code p1589
The ECM memory should have been
rest due to which the calibration of the accelerator pedal has been erased.
Use a scanning tool and calibrate
deceleration sensor.
You can do the calibration by
clicking Engine and ECT > > special function > > and then click
"decleration 0 point calibration" while you do that make sure that
your car IGN switch is "ON" and your gear shift is on "P"
2007 Toyota Yaris speakers aren't working
you must check the wiring it looks like some wire are damaged their connection to check the wiring you need the wiring diagram which will help you to locate the problem go to the given link you can get the diagram from the link it's a safe and secure link
http://toolsnyou.com/
Not finding what you are looking for?