20 Most Recent 2006 Toyota Highlander Questions & Answers

Question edited for clarity 'wine diagram'. Question moved to model category. For full wiring diagrams, there is usually a cost. You will find part diagrams if you Google 2006 Toyota Highlander (the part) wiring diagram https://www.google.com/search?q=2006+Toyota+Highlander+V6.+wiring+diagram Oxygen sensor wiring https://www.google.com/search?q=2006+Toyota+Highlander+oxygen+sensor+wiring ..

see your local dealer or mechanic sounds like the bcm has failed

In the 2006 Model the Cigarette lighter is located behind the small compartment on the drivers side dashboard left of the steering wheel. Simply lower the compartment door (Fuse box cover) and remove it to access the fuses. Jul 2010

RGC

This indicator light is used to display the working status of the automatic overspeed gear. When the indicator light is on, it means that the O/D gear is locked. At this time, the acceleration capacity is improved, but the fuel consumption increases. If the indicator light is not on, the possible fault points include: gateway damage, ELV electronic steering lock damage, key damage, comfort CAN line failure, drive CAN line failure, anti-theft function failure, steering column control unit failure, instrument control unit failure, and There may be strong signal interference from the outside world. You need to go to a professional repair shop to repair your toyota highlander or buy a new car, such as toyota calya.

It's almost always broken wires in a 3-wire ... Search for my prior solution under Nitram2. It's almost always broken wires in a 3-wire harness feeding the knobs. Toyota will skim you close to $1000 for this, claiming that you need to replace the control board. It's an easy half-hour soldering job.

there have been several complaints of these lights coming on together. you always have the option to bring the vehicle into the dealer but before you do that i would disconnect the battery from under the hood for 10-15 minutes and while disconnected press the brake pedal 30-35 times to drain any power remaining in electrical system and then reconnect the battery. there are numerous accounts of this reseting the computer,erasing any codes and returning drivability. if this does not work than yoou will have to go to the dealership. god luck and hope this helps.

dealer only

P0606 Toyota ECM Processor Error

The check engine light turns on because the computer has detected a problem, it sounds like there is a misfire, the first thing you should do is to connect a code reader to get the diagnostic codes, if you have no code reader and you live in the US then your local autoparts store can help you get these codes, try Autozone or one of the other national chain stores, if that's not an option you'll have to pay a shop to get the codes for you.

I agree with what you were told about turning the rotors. With the lower cost of replacement rotors and the metal in the original rotors, does make them hard to turn and stay true.

The problem is your CV joints have worn out and the only solution is to replace them. make sure to do both side as if you only do one the other will fail very shortly.

I have the same problem did you find any way to fix it?

check the timing chain for wear , check fuel injectors

Scan it. Find the codes, fix the problem.. Could be a bad wheel sensor.