Top 20 2002 Toyota RAV4 Questions & Answers

All the knowledge you need to fix any problem is in service and repair manual which will provide you step by step help to locate and fix the problem easily and you will get the manual from the given link https://toolsnyou.com

Check if the wiring is in tact to the sensor. If u have a I pin sensor ck for ground/ 2 pin ck for ground & 5v. 9 out of 10 times its a bad sensor. Ck coolant level too & fan operation

http://www.rockauto.com/en/catalog/toyota,2002,rav4,2.0l+l4,1388910,fuel+&+air It is in the fuel tank see attached link for schematic

Exhaust system will not trigger a random fire code. Spark plug gap could be out of range. The injectors could be a little pi\lugged up' Run some fuel cleaner in the next tank of gas. Then drive it until you get a definite miss number.

Change the battery in the remote key.

Push on the door, it probably pops open

computer box will need to be changed,the computer is programmed to read the pick up sensors of the camry and is not compatable with the rav4,whiering harness needs to be changed to fit the rav4 computer aswell as the key code sensor around the egnition.

Sounds like the engine needs and overhaul.

There is a reason and a body control module scan tool can pin point it when the fault happens.

There's no clogs. Your explanation tells me exactly what the problem is. Been there Bro. Your problem is caused by a faulty Exhaust Recirculation Valve (the EGR valve) and all you can do is just replace it. Those other mechanics that tried to fix it didn't know because apparently they've never come across this situation. But losing power when your pulling an incline tells you right away it's the EGR valve. Just buy one from your local auto parts store and replace it yourself. Only a couple of bolts hold it on and has a vacuum line on it.

5w - 30 fully synthetic for average driving conditions. 0w - 30 for temperatures below -5°

Yes, they need to breath or they try to turn the tank inside out. There should be a small tube on the topside of the filler tube. My bet is it's blocked. That's your stutter sorted. Auto or manual gearbox? What light comes on? Either way a clutch is due for replacement. Or I'm thinking maybe that light is for low hydraulic pressure in the auto gearbox. More information please.

It sounds like you are dealing with a transmission issue. When metal heats up, it expands. This would be the reason as to why the noise eventually goes away. Your gearing is slipping and will eventually give out. I would take it to someone I trusted an have them drain the transmission of it's fluid and have them look for metal shavings. This usually shows up when the vehicle has been mis-treated or has been put under severely heavy loads and it being pulled uphill. Inexperienced drivers don't know how to use the vehicle gears correctly and this eats the sprockets within the transmission slap out. Hope this helps.

The number is usually embossed on the block, beneath the exhaust manifold. Not normally viewable without taking the manifold off.

Look on the radiator to see if the wires got reconnected to the tepm sensor.

under hood towards front fender and grille is the washer tank at the bottom attached to side is pump

On what, year, make and model and what engine? If you need further help, I’m available over the phone at https://www.6ya.com/expert/edward_020b3320326d263d

Maybe a shorted speaker causing the power amplifier inside the radio to shut down or a speaker wire shorted to chassis and last the internal amplifier of the radio cd set faulty by itself... set volume to zero power it off take out the radio cd set; remove the speaker iso plug leaving the power plug only in and power it on if necesary turn again the volume down to zero and wait if it keeps turned on it a speaker problem if it shut itself off again then you go for a repair or a new one

its clear that the cable that links the handle to the back rest realease at the hinge of the seat has come off. to confirm this the seat back material needs to be striped but before stripping starts disconnect the battery because you will be disconnecting the sensor in the seat belt stalk which is part of the airbag system also if the seat has an airbag in it that also needs to be disconnected plus seat warmers or coolers connection then remove seat strip seat back material and fix

type year and model and vvti valve in google but click images it will give u diagrams, hope this helps