20 Most Recent
1987 Peugeot Liberte Questions & Answers
Re: peugeot 306 engine not starting after being hit in the front bumper
how hard was your car hit?? is it petrol or diesel? if its petrol the first thing that pops to mind is that, under the bonnet near the back (cant remember what side) you'll see a big red button, press it and try agaijn.. this is a knock sensor for if you ever have a crash... ive set one off just by parking and bumpin the car in front
I have a peugeot
check to see if you have power at the hazard light switch, it could just be unplugged, if u can get another good switch swap them over, i know its a power prob to that haz switch.
Peugeot 206 NEW clutch pressure and clutch plates
its likley to be the clutch center plate cush springs are loos and the center plate is warped so wnen you try to get into gear the clutch is draging the gear box around,,,bipping the clutch stops the clutch spinning so no noise! all you can do is strip the lot down again and fine the fault and fix it
Problem with electric window passenger side
Hi
Very common on the 306, the door wring from the inside of the door jar into the side of the dash board gets frayed and then the windows stop working or work intermitently, does the wiondo go up and down when the door is all the way open? try it and let me know.
Most likely it will be the wiring, please get back to me if you are unsure what I mean.
Regards
Dan
Peugeot 106 ecu
It will have to go to the dealership and be programmed to your car's VIN
307sw hoots randomly
check the horn button and contacts under the steering wheel for a short as the wheel is moved.
Timing on 1.9 diesel 806
There is no mark there is a hole in the block behind the starter motor which you have to insert a pin which locates into the flywheel to lock the crank into place you might find it easier to remove the starter motor
How do I set crankshaft timing
Behind the starter motor there is a hole in the block that goes into the flywheel it's about 6mm dia hole if you put a drill bit in the turn the engine by hand you should be able to feel it lock onto place you might find it easier to remove the starter motor to get to the hole
Expert van
possibly a battery problem Get an AVR check done that will check your power supply for the vehicle
Not finding what you are looking for?