20 Most Recent 1999 Lincoln Town Car - Page 5 Questions & Answers

If you have owned this car, the bulb is burnt. If you just purchased it. Most likely some has taken the bulb out. A code reader or scanner will still read the codes.

Turn your fan (a/c and heater) off. If the noise stops you know you have a dirty fan or it is going bad, Turn it on high and open all the vents, sometimes this will loosen it up. .Also, check your belts under the hood for squeaking. Never use belt dressing. Tighten them up or replace them..

Try Techron can clean carbon could reduce oil .

How many miles on the engine ? Worn piston rings ! worn timing chain , jumped time ! engine worn out !

Take it to a dealership they will help you

You can't plug a connector on the wrong sensor. Excluding dodge pt cruisers and neons. So I would check to see if he smashed wires between the intake and head.

The heater core is under the dash on the passenger side in the AC/Heater box and its a pretty big job to change . This is a 9 hour job you have to pull back instrument cluster from the firewall.

Sounds like a bad speed sensor, have the codes read.

Go to auto zone and have the codes checked. It sounds like a speed sensor

You should b able to google it and look at images or there should b a link to download a schematic to this or there's always youtube Regards Chris ..

A couple of quick things check fuel relay switch and fuses, Ignition switch also was the car bump or hit locate inertia switch in trunk area.

Should be in under hood fuse check Owner man could also be called flasher relay.

Owner man or shop man is best check helminc.com Service Manuals Owner Manuals Wiring Diagrams Service Bulletins Helm... also most cover to fuse box have basic info. If missing check wrecking yards or local dealer.

Could be bad fuse, bad ballast resistor or bad fan motor. You can test the motor by using a jumper wire straight from battery + to the single terminal right on the motor, if you can get to it. Ballast resistor is located under hood mounted in the heater box with two or three screws. If you unplug the wire connector from it and remove it you will see two spring like coiled wires. If one is broken, you have found the problem. If the fan does not run on any speed, most likely bad fuse. This can happen because trash/leaves get in the heater box and jam the fan which then overloads and blows the fuse. You may have to clean this out as well.

Assuming it's not the battery; have you replaced the battery cable ends that attach to the battery posts? It may look like the ends have a good clean connection to the posts but the problem may be with the cable side being corroded. Don't just clean, replace ends (they're cheap). Starting with the cheapest and easiest solution.

check for the correct bulb in the light and problems at the base of the bulb connection

It sounds like they didn't shut the air suspension before putting it on the lift and hyperextended the bag(s).

Here you go. Good luck.

YOU HAVE A PROBLEM IN THE FRONT END STERRING LINKAGE. THIS IS A VERY UNSAFE CONDITION. PLEASE PLEASE HAVE THIS CHECKED NOW!!!!

Sounds like your windshield is leaking take it to safe-light they will take a look and make recomendations