1995 Saturn Sl - Answered Questions & Fixed issues
95 saturn sl
gear shifting hesitates, what could this be?
Assuming it is an automatic transmission, I would look into that first. Check the fluid level. Low fluid level will cause hesitation. If your fluid level is ok consider changing the transmission fluid and transmission filter. Saturn's have an external filter, so it's very easy to do.
10/2/2019 7:22:52 PM •
1995 Saturn Sl
•
Answered
on Oct 02, 2019
•
92 views
AIr conditioner doesn't come on
There are pressure sensors in the refrigerant plumbing that can prevent the system from starting if system pressure is low. If any of these are loose or unplugged the compressor will never engage. The compressor clutch also has a connector that can be unplugged also.
7/4/2017 2:24:35 AM •
1995 Saturn Sl
•
Answered
on Jul 04, 2017
•
181 views
I have a Saturn SL2
Look in the manual. Probably a little button on the kick panel in the front passenger seat, just in front of the door. It resets a relay which trips if you roll over.
4/6/2017 5:21:32 PM •
1995 Saturn Sl
•
Answered
on Apr 06, 2017
•
275 views
My 95 Saturn SL "check engine" light
Call around to your local auto parts stores, most likely one of them will read your code for free and tell you what needs to be fixed if anything. (They're in the business of selling parts, so they're hoping the check engine can be fixed by a part that you can buy from them and replace.)Pep Boys, AutoZone, O'reilly, Advance Auto and Napa Auto have been known to read your codes for free.
9/6/2016 3:36:30 AM •
1995 Saturn Sl
•
Answered
on Sep 06, 2016
•
123 views
I cant find the fusebox on my 95 Saturn
Sedan, Coupe or Wagon ? Junction Block is under the hood at the front of the left inside fender area.Fuse Block inside of car is to the left of the steering column under the dash. This is on the SL with 1.9 SOHC Sedan
9/3/2016 5:02:43 PM •
1995 Saturn Sl
•
Answered
on Sep 03, 2016
•
240 views
I cant get my shifter to move out of park, i just replaced my ignition lock cylinder could it be some type of theft prevention?
They might. The shift interlock solenoid is controlled by the brake light switch. When the brake pedal is depressed the switch sends a signal to the interlock solenoid attached to the shifter assembly to allow it to release. Check to see if the brake lights are operational. If not, suspect a problem with the brake light switch. If brake lights are working, possible wiring to shift interlock solenoid or solenoid itself causing the problem. Your vehicle may be equipped with an interlock release button located close to the shifter to allow it to come out of park that can be depressed to release the shifter. Owners manual may provide more information on this procedure
3/3/2016 1:54:27 AM •
1995 Saturn Sl
•
Answered
on Mar 03, 2016
•
175 views
It's a 1995 Saturn sl the clutch on ac compressor kicks on with direct power the engine fan also changed relays still get the code 26 quad drive modal need some help
This info is from 1998 Saturn Sl , my service info doesn't go to 95 . It's the same except for code numbers , My info is P0xxx #'s . The quad driver is part of the ECM - engine computer !
Here is a description from Saturn service info .
A quad driver module (QDM) is an electronic switch which completes a ground circuit when switching ON. The QDM independently controls 4 separate outputs. A load is connected between battery voltage and the QDM allowing the QDM driver to control the output. Each QDM has fault detection logic which compares QDM driver input and output voltages. The logic expects to measure less than 3 volts when the QDM driver is ON and greater than 7 volts when OFF. The QDM has only one fault line that will detect a fault on any of the 4 outputs. The scan tool can be used to cycle the outputs ON or OFF. The scan tool can also perform an automated test which can isolate the faulty circuit.
The quad drive it self may be bad , GM had a problem with these !
Did you check fuse's ?
Conditions for Setting the DTC
DTC P01650 and/or P1651 will set if:
?€¢
There is an open, short to ground or short to voltage on any of the QDM output circuits
?€¢
MIL (SERVICE ENGINE SOON) telltale circuit
?€¢
Upshift lamp circuit
?€¢
Cooling fan relay circuit
?€¢
A/C relay circuit
?€¢
Fault detected for 5 seconds for DTC P1651. Fault detected for 20 seconds for DTC P1650.
Important: The QDM circuit is continuously checked when the engine is running.
5/18/2015 1:49:00 PM •
1995 Saturn Sl
•
Answered
on May 18, 2015
•
249 views
1995 Saturn engine revs up and engine runs hot and stall
I assume you mean the engine seems to idle high, quickly overheats and stalls. If that is the case, it may have a bad head gasket. To verify, check the coolant recovery bottle and look for dark engine oil floating on the coolant and/or excessive white smoke from the exhaust pipe. If neither of these symptoms are present, check the ECM for error codes - there is a chance the catalytic converter is plugged or something in the emissions system or the ECM itself has failed. Btw, I’m available to help over the phone in case u need at
https://www.6ya.com/expert/dave_fb2c45146b845cea
10/9/2014 11:37:09 AM •
1995 Saturn Sl
•
Answered
on Oct 09, 2014
•
77 views
Not finding what you are looking for?