20 Most Recent
2003 Jaguar Vanden Plas - Page 3 Questions & Answers
1992 jaguar vandreplas in limpe
This is caused usually by either multiple fault codes triggered or one(s) of a serious nature.You will need to make contact with a garage or dealer that can successfully read these and hopefully clear them.Any that don't clear will need repair in those areas,others that cleared should at least be inspected for obvious signs of fault,or make note of for later in case they return.Sometimes the fault can be in the ECU or the loom to it.check for dampness around it and poor connection in ecu loom plugs and its earth.I hope that this is of some help to you in getting to the source and repair.
2008 jaguar XJ Long
Hi, from your description it sounds like you have a wheel bearing problem in the rear of the car. It is common to have one or both wheel bearings fail causing a whirring type noise like the one you are hearing.
You can get the parts in the USA on this
LINK......
What is a ice head
The term ICE stands for In Car Entertainment. The head unit is the radio/CD player on your console or dash.
My driver side front door
Actually there is a plastic clip which holds the rod to the latch which breaks you may find it at any auto parts store in the HELP section or ask for assistance. It takes longer to take door cover off then to replace the clip.
Where is the power steering
There should be two hoses coming out of the steering box at the lower end of your steering column. Follow these hoses to the steering pump. Let me know if this helps. Thanks.
Need instruction on how to
Hi! Please perform the following procedure
a. loosen the wheels but dont take the lugnuts yet
b. secure the car by using a jack stand after you lift the car
c. remove the wheels
d. loosen the nuts on the top of the shocks from the inside
e. loosen the bolts that holds the shocks
f. Loosen the nut that holds the spring but be sure that you use a special tool to hold firm the spring for this may cause serious injury if it pops out.
g. you'll gain access to the shock absorbers and you may replace it
h. do the procedure vise versa on installing
Hope this helps and thank you for using FixYa!
CHECK ENGINE LIGHT
two sensors replaced-
fuel ejector cleaned\
new catalytic converter
light on again
My car has electrical problems.
This is called limp mode.
The TCM (tranny control module) usually stores error codes and can be scanned to find out why the tranny is in limp mode.
Sometimes the In and Output speed sensor causes this problem but your speedometer would likely not work right.
A bad ground from battery to tranny could cause this.
Another cause is the rear transmission mount fails and puts stress on the wiring loom
causing it to fail. Fix is to replace the mount and the loom
Where is the ecu located
Front seating area, passenger side, under dash, mounted behind kick panel. Please let me know if you need anything else.
Whats the difference between the
it depends on what parts that are needed. Many parts do not interchange for the computerized system had changes each year built
My transmission make a cliking
A couple of things, your trans fluid could be low (shouldnt cause it to pop out of gear) but check it too and the motor/trans mounts are probably bad causing the trans to slip out of gear;
Not finding what you are looking for?