20 Most Recent
2002 Saturn S-Series - Page 8 Questions & Answers
My 1997 Saturn will not hold a charge on the battery
theres a draw on batt. start pulling fuses one by one for a few days over nite and the circit will reveal its self. if you have a volt meter you can do same thing faster by conectin it between batt cable and batt (power must pass though meter)
I have a1997 saturn
havit scanned today -----hav u done a major tuneup--throttle body and idle air cleanin--check egr valve and catalytic converter--new plug wires and distributer cap--------these dont show up on a scan----vacuum leaks dont show as codes either
My odometer isnt working on
kits to fix that common pre 96 saturn problem are sold on eBay, as well as already fixed clusters. so find a how to video on youtube and see if you are up to pulling the cluster and doing the repair. to pay someone to do this will exceed the value of the car. it will not be worth one more dollar with a working odometer, i would just live with it.
I have a 2000 sw
it may be the sensor that activates the fan that is faulty & needs to be replaced......cheers.
Check engine ligth
do you mean your chek egine light on, if it is. I think your car has the obd2 code problem, and you can take it to the repair shop, they will read out the code for you and then delete it, hope help.
My backup lights does not
make sure both bulbs are good, then take a look at the neutral lock out switch. that switch prevents you from running the starter unless in neutral or park, and turns on the back up lights when reverse is selected.
I have a 2002 saturn
What you can do is remove the knuckle from the vehicle. This would include removing the brake caliper and rotor, separating the lower ball joint from the knuckle, separating the tie rod end from the knuckle, removing the axle nut, and finally removing the two bolts that hold the knuckle to the strut.
With the knuckle removed you can then bring it to a machine shop or a local auto repair facility to have the old bearing pressed out of the knuckle and the new bearing pressed back into the knuckle. There is no way you will make a tool to do this. You will need to use either a press or a specialty product called a hub shark which requires an impact wrench to remove and install the bearing.
Once the knuckle is reinstalled onto the vehicle it is vitally important to torque the axle nut to the proper spec. Failure to do so will cause the bearing to fail.
Let me know if you have any other questions. I’m happy to assist further over the phone at
https://www.6ya.com/expert/jeremy_d728a59f986299fa
Automatic seatbelt doesnt work
if neither ther passenger or the driver seatbelt work it is a fuse. if not it is as simple as changing the door switch. if you dont see a visible door switch it is actually in the door and you should notice a door ajar light in the dash if the switch isn't working.
My saturn makes a noise
if it sounds like a tin-metal rattle, it is your abs unit switching on (about 3-4 miles per hour)-if you remove the connector to it (in front of the master cylinder) your abs light will go on-shut the car off, start it, and drive-no noise. It only does it when you first move after starting, or if the ABS is engaged like braking hard on a slippery surface. the fact that your lights dim means you should check the condition of your battery and alternator, since when the ABS is activated it draws a decent amount of current. It might be an early advance warning that your battery or alternator are not up to snuff.
Not finding what you are looking for?