Top 20
2006 Saturn Vue Questions & Answers
Replace a lighter in a 2006 satran vue
Check your owners manual for the location of the light fuse and check it, if that's not the issue pick up a replacement lighter at your local parts store and it's a simple install, just unplug the old one and plug the new one in once it's mounted in your ashtray or wherever it may be. A simple fix, no Worries!
I have a '06 saturn vue 4cyl. the battery died
Sounds like your IAC (Idle Air Control) valve may not be functioning properly, although not at all related to a battery change.
Are you getting a check engine light? If yes, then take it to any auto-parts store for a free scan to determine any fault.
2006 Saturn vue, 4 cylinder. Ran out of gas, couple gallons put in, ran fine. Went to gas station filled up full. Driving home, noticed my reduced power indicator flashed a few times on then off. Once
reduced power , electronic throttle control problem .
Reduced Engine Power Mode
When the ECM detects a condition with the TAC system, the ECM may enter a reduced engine power mode. Reduced engine power may cause one or more of the following conditions:
• Acceleration limiting--The ECM will continue to use the accelerator pedal for throttle control; however, the vehicle acceleration is limited.
• Limited throttle mode--The ECM will continue to use the accelerator pedal for throttle control; however, the maximum throttle opening is limited.
• Throttle default mode--The ECM will turn off the throttle actuator motor and the throttle will return to the spring loaded default position.
• Forced idle mode--The ECM will perform the following actions:
- Limit engine speed to idle by positioning the throttle position, or by controlling the fuel and spark if the throttle is turned off.
- Ignore the accelerator pedal input.
• Engine shutdown mode--The ECM will disable fuel and de-energize the throttle actuator.
2006 saturn vue rough idle
Look at tube from air cleaner filter back to the engine ,make sure there are no splits in the intake tube , air getting past the mass air sensor sends bad signals to the ecm.
Not finding what you are looking for?