Top 10 2003 Lincoln Town Car Questions & Answers

03 Town Car transmission whines & taps on very hot days only, changed fluid filter, trans cooler & radiator. Runs great on cool on days under 90 degress.

yes i agree with ripoff, If you are unable to do it yourself , then I suggest you go to a regular shop, and they should replace it with minimal cost, buy the part for eight dollars and bring it with you to the shop so that all you have to pay is labor, if it is really easy like i suspect you may not be charged at all, or even ask one of the guys if you give them a couple of bucks will they switch it real quick.
hey, I would do it..

where is the antenna wire located on the 2003 Lincon Town Car?

SECTION 501-05: Interior Trim and Ornamentation 2003 Town Car Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 01/28/2002 Front Door Trim Panel Printable View (206 KB) Removal and Installation
NOTE: LH side shown, RH side similar.

1. Disconnect the battery ground cable. For additional information, refer to Section 414-01.

1. Remove the window switch plate.

1. Disconnect the electrical connectors.

1. CAUTION: Use care not to damage the trim panel covers.
   Open the screw covers.

1. Remove the screws and the assist handle.

1. Remove screws and the front door trim.

1. Disconnect the electrical connectors.

1. To install, reverse the removal procedure.

I suggest check the Lincoln TonwCar owners manual (page 160 and next)...



Hope this help (remember comment and rated this).

bottom line is the U1262 is a communication failure between your scanner and a module

assuming you actually pulled the code from the PCM then you have lost communication with a different module like the ABS, DDM, LCM, RASM, HEC, PAM and any other module I can't think of right now

You need a detailed pinpoint test from a Ford service manual or aftermarket source like Alldata, Shop key or Mitchell on Demand

You could be dealing with over a 100 different test PER module

Obviously something we can't do on-line too easily

If you could at least identify which module you have lost communications with your dealer may, for a fee, copy the correct pinpoint test

Go to this FREE Ford website to view or download the owners manual for this vehcile, the fuse block diagram is on page 189.
The fuse for the trunk release in in position 30 in the fuse block and is a 7.5 amp.

https://www.fleet.ford.com/maintenance/owners_manuals/results.asp

We would like to point out that your car already has a well-placed fuse box diagram located on the inside of the fuse box cover. However, if that's not the case visit this link to know where each fuse lays and what it does: https://knigaproavto.ru/shemy/en/lincoln/town-car/607-2003-2011-lincoln-town-car-fuse-box-diagram.html

passenger side on firewall.. here is a link to a picture of it. http://www.automotix.net/images/products_small/lkq/ebx_category.jpg

There is a gear inside the black plastic enclosure under the drivers seat that its teeth are stripped or worn off. Remove black plastic enclosure from frame. Drill out rivets to open up the black housing. Locate passenger seat assembly from junk yard that works. Disassemble unit, remove same gear and install it in drivers seat assembly. You will have to use either a small gear puller or shop press to remove bad gear and definitely a shop press to install good gear. Reassembly in reverse.