20 Most Recent 2003 Lincoln Town Car Questions & Answers


no inline switch just a switch in the trunk driver side

2003 Lincoln... | Answered on Sep 19, 2019


When changing a battery alternate power supply should be hooked up so modules an radio don't lose settings .
https://www.aa1car.com/library/battery_disconnect_problems.htm

To get working again you would need to hook up a factory scan tool ,check codes , see if the control module for those systems can talk with the scan tool etc.... IF not , module would need to be replaced .

  1. Verify the customer's concern.
  1. Visually inspect for obvious signs of mechanical or electrical damage.

    Visual Inspection Chart Mechanical Electrical
    • Damaged exterior rear view mirrors
    • Damaged interior rear view mirror
    • Battery junction box (BJB) fuse(s):
      • 104 (40A)
      • 108 (30A)
    • Central junction box (CJB) fuse(s):
      • 17 (10A)
      • 18 (7.5A)
      • 28 (10A)
      • 30 (7.5A)
    • Damaged battery junction box (BJB)
    • Damaged central junction box (CJB)
    • Damage to wiring harness
    • Loose or corroded connections
    • Damaged exterior rear view mirror control switch
  1. If the inspection reveals obvious concerns that can be readily identified, repair as necessary.
  1. If the concern remains after the inspection, connect the diagnostic tool to the data link connector (DLC) located beneath the instrument panel and select the vehicle to be tested from the diagnostic tool menu. If the diagnostic tool does not communicate with the vehicle:
    • check that the diagnostic card is correctly installed.
    • check the connections to the vehicle.
    • check the ignition switch position.
If the diagnostic tool still does not power up, refer to the diagnostic tool manual.
  1. Carry out the diagnostic tool data link test using the diagnostic tool. If the diagnostic tool responds with:
    • SCP+, SCP- or ISO circuit fault; all electronic control units no response/not equipped refer to Section 418-00 .
    • No response/not equipped for Driver Door Module (DDM), refer to Section 419-10 .
    • No response/not equipped for Driver Seat Module (DSM), refer to Section 419-10 .
    • If the DDM is not listed for a communication concern, turn the ignition switch to RUN, make sure all doors are closed, retrieve and record the continuous diagnostic trouble codes (DTCs), erase the continuous DTCs, then execute the Self-Test Diagnostics for the DDM. If the DDM exits diagnostic state during the self-test and returns to normal operation state, refer to Section 419-10 .
    • If the DSM is not listed for a communication concern, turn the ignition switch to RUN, retrieve and record the continuous diagnostic trouble codes (DTCs), erase the continuous DTCs, then execute the Self Test Diagnostics for the DSM. If the DSM exits the diagnostic state during the self-test and returns to a normal operating state, refer to Section 419-10 .
  1. If the DDM DTCs retrieved are related to the concern, go to the Driver Door Module (DDM) Diagnostic Trouble Code (DTC) Index to continue the diagnostics.
  1. If the DSM DTCs retrieved are related to the concern, go to the Driver Seat Module (DSM) Diagnostic Trouble Code (DTC) Index to continue the diagnostics.
  1. If no DTCs related to the concern are retrieved, go to the Symptom Chart to continue the diagnostics.

2003 Lincoln... | Answered on Mar 08, 2019


There's a website that has all this information about all this and manuals everything totally free there are many actually but I personally like few .. let me know if u need help
thanks

2003 Lincoln... | Answered on Feb 26, 2019


Usually a sign of failing wheel bearings. Does is change speed or pitch depending on how fast you are going? That is the test. If is it there all the time, it is likely to be the fuel pump.

https://www.google.com/search?client=firefox-b-d&ei=RJB0XNq3MIbz5gL2673QBw&q=symptoms+of+failing+rear+wheel+bearing

2003 Lincoln... | Answered on Feb 26, 2019


I have a owners Manuel with that page I do not know how to send it to you

2003 Lincoln... | Answered on Feb 23, 2019


That is Limp Mode

P1235 FORD Fuel Pump Control Out of Range - AutoCodes


https://www.autocodes.com/p1235_ford.html

P1235 Ford Description. The P1235 code indicates the Fuel Pump Drive Module (FPDM) detected an invalid or missing Fuel Pump (FP) circuit signal from the Powertrain Control Module (PCM). The FPDM sends a message to the PCM through the FPM circuit, indicating this failure was ...

C1123 Front Right Out ABS Solenoid - AutoCodes


https://www.autocodes.com/c1123.html

Circuit of front Right Output ABS solenoid is open or shorted, or control line is open or shorted to power supply or ground. ... C1123 FORD Vehicle Speed Sensor Input Short to Battery. ... C1123LINCOLN Vehicle Speed Sensor Input Short to Battery.


2003 Lincoln... | Answered on Feb 19, 2019


When you turn the key to run or start is the theft light on or flashing ? Sorry but their is no deactivating , it's software programmed into the vehicle control systems . The dealer couldn't even do that with a factory scan tool . You need to see what DTC's - diagnostic trouble codes are stored , diagnose the problem and fix it .

2003 Lincoln... | Answered on Jun 27, 2018


Hi I would reccomend both above suggestions, but when you try taking the positive terminal off give it 5 minutes or so to let your electrical system fully discharge

2003 Lincoln... | Answered on Jun 26, 2018


has anyone checked for a vacum leak? a vacum leak will cause rough idle at idle. check the lines from the pcv valve.

2003 Lincoln... | Answered on Jan 04, 2018


the black will always be factory negative wire

2003 Lincoln... | Answered on Aug 03, 2017


where is the antenna wire located on the 2003 Lincon Town Car?

2003 Lincoln... | Answered on May 16, 2017


are you speakers blown? is it stock? do you get any static at all?

2003 Lincoln... | Answered on Apr 08, 2017


Either the window lift motor is defective or the window regulator assembly is jammed.

2003 Lincoln... | Answered on Feb 22, 2017


No engine Oil RESET:

I have had & serviced a 2000 Lincoln & 2004 Lincolns....
(and the FACTORY WORKSH MANUALS FOR EACH)

Performing every oil change myself.

If you have an oil light and your engine is not clattering
you might want to consider replacing the oil pressure sender switch ...

ELSE
You have an Oil Pump/worn-engine issue to be looking at...
(FREE schematic assessable at BBB Industries site at very bottom (Real diagrams = registration required).

2003 LINCOLN TOWN CAR 4 6L V8 Oil Pressure Sender Switch RockAuto

More Information for MOTORCRAFT SW6357

2003 Lincoln... | Answered on Feb 10, 2017


Hi,

I would check the Transmission fluid.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/laura_08254539050d64db

2003 Lincoln... | Answered on Jul 29, 2016

Not finding what you are looking for?
2003 Lincoln Town Car Logo

510 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Lincoln Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

gerry bissi

Level 3 Expert

4388 Answers

fordexpert

Level 3 Expert

5692 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Town Car Lincoln

  • Town Car Lincoln

Most Popular Question

2003 lincoln town car trunk lid open

  • Cars & Trucks
Loading...