20 Most Recent 2004 Honda Accord - Page 4 Questions & Answers


I have a similar problem, my tailgate stopped working with the outside handle and the remote but can be opened manually from the inside. I don't have an alarm so there is no problem with that but did you get a solution for the tailgate problem that I could try?

2004 Honda... | Answered on Nov 23, 2015


If all of the door locks are not working, the problem is likely a fuse or a bad relay. If only one is inoperative, then the switch is likely the culprit

2004 Honda... | Answered on Nov 03, 2015


I will assume you know there is a button on the dash to turn the TCS on and off. Make sure that button has not been pushed. The brake light can be on due to worn brake pads or low fluid level. If the TCS is not turned off then I suggest you take the car to a trusted mechanic or to your local Honda dealer and have it looked at. It takes skill, knowledge, and the proper tools to diagnose this type problem. It can be many things including a sensor, and you can spend lots of money guessing. Spend the money to have it repaired by someone who knows what they are doing. You will be money ahead and have it done right the first time.

2004 Honda... | Answered on Aug 26, 2015


TCS stands for Traction Control System.
The traction control system works in conjunction with your Antilock Brake System (ABS) and your Engine Control Module (ECM) or Powertrain Control Module (PCM) or Electronic Control Unit (ECU) (Note that ECM, ECU, and PCM all mean the computer that controls your engine, depending on make.)

Anyway, the traction control system can apply one or more of the brakes and control engine RPM in the event that a wheel slip has been detected by the traction control system.

Pushing the TCS button on most models will light a lamp in the instrument cluster that usually says "Trac Off" Pressing it a second time will turn this light back off.

When the "Trac Off" light is illuminated, the Traction Control System is disabled and will not work in the event of a wheel slip.

Also note that when the Traction Control System is working and a wheel slip is detected, The Traction Control Module will usually illuminate a light that says "Trac" as it is taking control of your brakes and engine. It can feel really strange when this occurs and some people think that their transmission is slipping or that their engine has a misfire problem.
The chances are that if it occurred on wet, slippery pavement, the Traction Control System may have just saved your life.

If this is happening on dry pavement and normal driving conditions (starting, stopping, or turning), there may be a problem with the system. "False Traction Control" can happen just like a bad wheel sensor causing "False Antilock Mode".

Also check your Owners Manual for more specific information pertaining to your particular vehicle.

2004 Honda... | Answered on Jul 09, 2015


Possibly a bad electrical section of the ignition switch. Fairly common, available aftermarket. But check with Honda, too, some of them are less expensive at the dealer!

2004 Honda... | Answered on Jun 15, 2015


plan on removing the dash to get to it . then go buy a manual read what needs done and you might take it to a mechanic

2004 Honda... | Answered on May 27, 2015


double posted, why do that?
and again shows 2 cars, why post 2 cars> makes
very confusing. s

2004 Honda... | Answered on Apr 30, 2015


check fuse
check connections to rear of radio.
if good the Radio is inop. get it fixed.

2004 Honda... | Answered on Apr 30, 2015


If the battery was below five volts when you jumped it. It is a normal security feature. It should reset after you put the key in to start.

2004 Honda... | Answered on Apr 25, 2015


either trans is no good or you don't have gear linkage hooked up right

2004 Honda... | Answered on Apr 15, 2015


if not completely installed remove belt and start over. marks must be directly in line. if you have already completed the installation, you have to dismantle it again to correct this. if trying to set timing without dismantling, the distributor will not be correct and engine timing will be incorrect and run poorly

2004 Honda... | Answered on Apr 01, 2015


Your ECM (car's brain) has reduced your car to Limp Mode. You'll need a Fault Code Reader and list of fault codes for your vehicle to diagnose the problems. Fault code readers aren't expensive and Haynes makes inexpensive DIY manuals for your vehicle. Could be the EGR, PCV valve, TPS, or Oxygen Sensors. Each of these has a separate fault code... please check a fault code reader and verify the fault against the list in Emission Controls list in the Haynes manual. This will narrow it down for you.

2004 Honda... | Answered on Mar 30, 2015


Try to check the throttle position sensor, or idle control valve is equipped

2004 Honda... | Answered on Mar 30, 2015


Hi, the alternator is not needed to start the car, so it may be just fine. Problem is likely in the start circuit.

Please see my tip at http://www.fixya.com/cars/r6222268-engine_doesnt_crank_turn_over . These are generic instructions. If you get stuck or need specific instructions for your car, please get back to me with model, year and engine info.

2004 Honda... | Answered on Mar 29, 2015


Replace your glow-plugs with the proper ones from DENSO.

2004 Honda... | Answered on Mar 23, 2015


This could be a bad wheel bearing.
If it happens only in a turn, it could be a CV joint.
Some brake systems have a brake warning that scrapes on the disk to let you know. It could be bent or out of place.
Hope this helps.

2004 Honda... | Answered on Mar 19, 2015


There are many issues that can cause this. Most common are fouled spark plugs, clogged fuel injectors, bad Oxygen sensors, PCV valve stuck, broken or disconnected vacuum lines. DFENSO plugs and O2 sensors will fix those problems. Vacuum lines require a thorough inspection using the diagram inside the hood; tracing every line and inspecting for cracks. Your fuel injectors are also DENSO, they can be cleaned using specialized machines... a Bosch service center has the machine to clean them and test the spray pattern for proper flow. Vacuum lines are easy to replace and the PCV valve just screws on. If these don't work, then you have an ECU problem. Rebuilt ones are available on line for around $100.

2004 Honda... | Answered on Mar 12, 2015


The P0141 code points to the O2 sensor heater circuit. It could be that there is a short in the wiring to the O2 sensor or it could be that the O2 sensor heating element itself is bad. The code is for O2 sensor Bank 1 Sensor 2. Bank 1 means its the O2 sensor connected to the exhaust pipe that runs to cylinder #1. Sensor 2 means that it is likely the O2 sensor after the catalytic converter on the same exhaust pipe.

2004 Honda... | Answered on Mar 10, 2015

Not finding what you are looking for?
2004 Honda Accord Logo

2,042 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1992 Honda Accord
1992 Honda Accord

2,940 Questions

1991 Honda Accord
1991 Honda Accord

2,649 Questions

1995 Honda Accord
1995 Honda Accord

1,606 Questions

1996 Honda Accord
1996 Honda Accord

1,608 Questions

1998 Honda Accord
1998 Honda Accord

1,531 Questions

Top Honda Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Accord Honda

  • Accord Honda

Most Popular Question

uneven tire wear struts problem

  • Cars & Trucks
Loading...