20 Most Recent 1995 Honda Accord Questions & Answers

Question edited for clarity. Question moved to model category. There are three ways to get the code. All mentioned in the link. https://www.fixya.com/support/r29874205-need_vehicle_radio_code ..

Hi, a few questions 1st. Did your mechanic check for engine codes? Is your Honda a v-6 or 4 cylinder?
The flashing D4 light indicates a possible transmission malfunction. You should avoid rapid acceleration until the cause of the light blinking is determined.
If you have the V-6, there is a diagnostic port to connect a scan tool to read any stored engine codes that have turned on the check engine light. This port is located behind the ashtray in the center console (most cars did not have this til 96).
If you have the 4 cyl engine, there is a service connector located under the dash on the pass. side. Inside the connector is what looks like a 2 wire plug should be attached. Take a paper clip, unbend it, and insert the 2 ends of the clip into the connector to 'jump' it. Turn the ignition switch to the on position (don't start the vehicle), and the check engine light will flash. Count the flashes, short flashes are for code #'s 1 to 9 (single digit code), a 2 digit code will be a long flash for the 1st digit, followed by a short flash for the 2nd digit. If there is more than one code, they will be separated by a pause. They will repeat so you can count them and write them down. Let me know what the code #'s are so I can help further. Curt

Red/white is left high beam and red/yellow is left low beam. Red/orange is right high beam and red/green is right low beam.

the best thing you can do is pull the code and work from there.

http://www.cb7tuner.com/vbb/showthread.php?t=21259

this thread shows you how to pull the code without using a scanner. its pretty simple. the only reason i can think of why your d4 and check engine light would go on at the same time would be either the main relay you installed is not the correct one or the speedometer is giving problems now. hope this helps. goodluck, and if you need more assistance, let me kknow

The windshield is actually a piece of safety equipment designed to hold you inside the car in a horrific accident. Once the windshield has a crack, the integrity of the safety equipment is compromised and should be replaced. Repairing it is not suitable. If your seat belt was ripped in half, would you feel comfortable sewing it back together? I hope not.

*** Please click the "Was this helpful? Yes" (thumbs up)! ***

FREE and EASY methods to get your Honda radio UNLOCK CODE. (Dealerships usually charge)

Assuming you don't have the Anti-Theft Code and Serial Number that is found on the credit card sized Anti-Theft Radio Identification Card that comes with the vehicle at the time of purchase and is usually found in the glove compartment....

You have FREE options to retrieve that code by phone or on the internet BUT, the RADIO SERIAL NUMBER is REQUIRED (no matter what). (see bottom about removing ERROR E3)

***IF your Honda was made BEFORE 2001 the serial number MAY not be accessible without removing the radio from the vehicle.***

* TO GET THE SERIAL NUMBER (so that you can get the unlock code)

1. Get something to write with and on (you'll need it to write down the serial number)
2. Put the ingnition key in and turn it until your able to turn your radio on (accessories position).
3. Then turn your radio OFF by it's knob/button (but leave the ingition key in place).
4. Hold down the preset buttons 1 and 6 at the same time.
5. Turn the radio on while pressing down both the 1 and 6 buttons.(***IF your Honda doesn't have preset buttons on the radio then hold down the top part of the 'Seek/Skip' button AND the top part of the 'Change Disk' button instead.*** )
6. Write down the 4 numbers you see first and then 4 more that display. These eight numbers are the SERIAL NUMBER. This is NOT your CODE.
7. Make sure your VIN (Vehicle Identification Number) is handy to get the unlock code. (can be found on your insurance card, driver's side door jam, small plate on dashboard by registration and inspection stickers, etc)

* TO GET THE UNLOCK CODE (using the radio Serial Number and VIN)

---Internet option:

1. Go to https://radio-navicode.honda.com/ (YES, it's run BY HONDA and IT'S FREE)
2. Follow on screen instructions (Serial Number and VIN required)
3. Type in the 5 digit code into your radio. This will unlock the radio and return it to a functional state.

-OR-

---Telephone option:

1. Call American Honda Customer Relations (800) 999-1009
2. When the automated message starts 'Press 3' for 'Radio and Navigation Codes'.
3. Tell the Customer Service Agent you need your radio code. (They will ask for your name, your radio's serial number, VIN, etc)
4. When they give you your radio unlock code--WRITE IT DOWN and KEEP IT SAFE!
5. Type in the 5 digit code into your radio. This will unlock the radio and return it to a functional state.

* REMOVING ERROR E3

****If you entered too many wrong codes and got an ERROR E3 message displaying you'll need to do an additional step for even the correct unlock code to work.****

Disconnect your negative battery terminal (or pull the radio fuse out if that's easier for you) for 30 seconds then reconnect it and then the radio will say "CODE" again and you can put in your correct unlock code.

-----------------------------------------------------------------------------------
So what happened to begin with?
See also: http://automobiles.honda.com/information/frequently-asked-questions.aspx?Question=2

If the power from your battery to the Honda radio is interrupted the Anti-Theft feature kicks in, the radio is rendered inoperable and the screen reads 'CODE'. You must enter in the Anti-Theft Radio Unlock Code (usually 5 digits) to make it operational again. You know that much by now.

the only wat ot get factory code is to get serial nu# on back of radio and call dealer

FREE and EASY methods to get your Honda radio UNLOCK CODE. (Dealerships usually charge)

Assuming you don't have the Anti-Theft Code and Serial Number that is found on the credit card sized Anti-Theft Radio Identification Card that comes with the vehicle at the time of purchase and is usually found in the glove compartment....

You have FREE options to retrieve that code by phone or on the internet BUT, the RADIO SERIAL NUMBER is REQUIRED (no matter what). (see bottom about removing ERROR E3)

***IF your Honda was made BEFORE 2001 the serial number MAY not be accessible without removing the radio from the vehicle.***

* TO GET THE SERIAL NUMBER (so that you can get the unlock code)

1. Get something to write with and on (you'll need it to write down the serial number)
2. Put the ignition key in and turn it until your able to turn your radio on (accessories position).
3. Then turn your radio OFF by it's knob/button (but leave the ignition key in place).
4. Hold down the preset buttons 1 and 6 at the same time.
5. Turn the radio on while pressing down both the 1 and 6buttons.(***IF your Honda doesn't have preset buttons on the radio then hold down the top part of the 'Seek/Skip' button AND the top part of the 'Change Disk' button instead.*** )
6. Write down the 4 numbers you see first and then 4 more that display. These eight numbers are the SERIAL NUMBER. This is NOT your CODE.
7. Make sure your VIN (Vehicle Identification Number) is handy to get the unlock code. (can be found on your insurance card, driver's side door jam, small plate on dashboard by registration and inspection stickers, etc)

* TO GET THE UNLOCK CODE (using the radio Serial Number and VIN)

---Internet option:

1. Go to https://radio-navicode.honda.com/ (YES, it's run BY HONDA and IT'S FREE)
2. Follow on screen instructions (Serial Number and VIN required)
3. Type in the 5 digit code into your radio. This will unlock the radio and return it to a functional state.

-OR-

---Telephone option:

1. Call American Honda Customer Relations (800) 999-1009
2. When the automated message starts 'Press 3' for 'Radio and Navigation Codes'.
3. Tell the Customer Service Agent you need your radio code. (They will ask for your name, your radio's serial number, VIN, etc)
4. When they give you your radio unlock code--WRITE IT DOWN and KEEP IT SAFE!
5. Type in the 5 digit code into your radio. This will unlock the radio and return it to a functional state.

* REMOVING ERROR E3

****If you entered too many wrong codes and got an ERROR E3 message displaying you'll need to do an additional step for even the correct unlock code to work.****

Disconnect your negative battery terminal (or pull the radio fuse out if that's easier for you) for 30 seconds then reconnect it and then the radio will say "CODE" again and you can put in your correct unlock code.

Have you ever change the fuel filter
Even the air filter.

Leaking trunk seal or rear window sealer also check the tail lights are mounted properly and that the trunk is closed all the way

Code 13 Barometric pressure sensor

I have this same old 95 Accord, four cylinders. It started with two of the spark plugs were going back, causing the radio to cutoff suddenly. The engine stops once awhile and bad mileage. Battery did not last long. I have to disconnect the radio antenna, as there was a short. Do not know if these can help. Good luck.

sounds to me like you have a ground issue.

Donde esta el OBD2 del honda odyssey a?o 1999, no lo logro encontrar. ? ayuda gracias.

have you tested the switch it could be your fault

-Sounds like it has bad ground. -Check it out and tight or redone the main ground. You should be good to go. Good Luck Mai

Before replacing the fuel pump an finding out it isn't the problem ,have the vehicle checked . Could be ignition system problem , bad ignition module .Check for spark After it shut's off . No spark would sound the same way ( sounded like it wasn't getting gas. )