20 Most Recent
1993 Subaru Legacy - Page 4 Questions & Answers
How to change waterpump on 93 subaru 2.2
Big job.. Strip to and remove all cam belt covers etc. then remove water pump and replace. Check out and replace belt and tensioners and idlers as required while there. Get a manual..
I have a subaru 1993 ej20t and clutch is
You will need to replace the clutch plate.Also on Subarus, check the condition of the flywheel as this is prone to cracking on 4x4 models. Replace if it shows signs of cracking, otherwise this may cause clutch judder after reinstallation.
1993 Subaru Legacy 2.2? Changed timing belt,
did you know how to replace timing belt it has to be installed in a specified way or it wont start
if it broke and you replaced it then the story is different as if it breaks while running usually it also bends your valves you should see a technician for this
Throttle position switch
This sensor sends the ECU an output signal which corresponds to the
opening of the throttle valve. Using this output signal, the ECU
precisely controls the air/fuel ratio during acceleration, deceleration
and idling. The TP sensor and the throttle switch are combined as part
of an assembly. The switch signal turns ON only when the throttle is
opened to the idle position or at Wide Open Throttle (WOT) acceleration.
REMOVAL & INSTALLATION
( see Figures 2, 3, 4 and 5
)
Fig. 2: Disconnect the wire harness from the throttle
position sensor-Legacy
Fig. 3: Paint a matchmark on the sensor and throttle body for
ease of installation and adjustment
Fig. 4: Remove the sensor retainer screws
Fig. 5: Lift off the throttle position sensor
-
Disconnect the negative battery cable.
-
Disconnect the throttle sensor electrical harness.
-
Place a matchmark on the throttle position sensor and throttle
body mounting surface, so that during installation, the sensor can be
properly aligned.
-
Remove the 2 screws securing the throttle sensor to the throttle
body assembly.
-
Remove the throttle sensor by pulling it in the axial direction of
the throttle shaft.
-
Remove the throttle sensor O-ring and discard.
To install:
-
Using a new throttle O-ring, install the throttle sensor, aligning
the matchmarks. Install and hand-tighten the retainer screw.
-
Connect the throttle sensor electrical harness.
-
Connect the negative battery cable.
Hope this help (remember rated and comment this). Good luck.
Need to know what causes this noise.
Hi its a common problem for these model legacys to tick due to the tappits, if it never used to do it then there is prob no damage to them, only dirt stuck under them so some good oil and some engine flush should help, or else try some anti tappit noise treatment in the oil your using now and it may also help
Not finding what you are looking for?