1993 Subaru Impreza - Answered Questions & Fixed issues
1993 Subaru Impreza 1.8l. I was wondering if anyone may know how and which spark plug wires go? Two are short and the other 2 are long. Thanks
the last video is for wrong engine of 5 enginehis (OP) is 1.8L boxers and has a Distributor. 4 cyl2nd video is wrong, no distributor. has coil pack2nd video is 2005 and worthless.1st video, is wrong too, is OBD2 car, 1993 is not.1st video does not distributormost youtubers never ever tell year nor which of 5 engines are there,and watchers pull hair out endlessly. (wasted time and efforts)this car goes back to 1992 , vast changes,by year1996 (first obd2 )1.8L has 4 lug DIS coil packthat too has special connections, ask for helpboxer is h4 engine, H= horizontal.all answers USAif not here engine spark can be totally different world wide.ours had a distributor 1.8L USA. EJ18 engine.1992 to 2023 car,but wiki says1998 (the same year the 1.8-liter engine was droppedso is only a 6 year run.(1.8l)31 year run, all engines. other 5 (set)
6/27/2023 11:00:49 PM •
1993 Subaru...
•
Answered
on Jun 27, 2023
•
84 views
'93 subaru impreza wont start
If it's quiet enough, turn the key to the "on" position without cranking it, then stop and listen for a humming or buzzing sound. If you don't hear it, your fuel pump may be having issues.
1/4/2018 3:39:35 PM •
1993 Subaru...
•
Answered
on Jan 04, 2018
•
294 views
FRONT INNER CV JOINT POPPING OUT
check and see if seal is damaged then try to push the axle back in you may have just popped out the axle from transmission if your lucky
5/5/2017 11:58:32 AM •
1993 Subaru...
•
Answered
on May 05, 2017
•
159 views
Wheel locking after accident/replacing passenger side tire.
wheel bearing will rumble treads on all 4 tyres matching?correct pressurefauty wheel sensor that side seized/leaking caliper piston or pads worn a flat spot on damaged side tyrelost a weight dammaded rim /mag strut or bush damage
3/11/2017 8:17:04 AM •
1993 Subaru...
•
Answered
on Mar 11, 2017
•
57 views
Changed light bulb on 1993 subaru impreza now car won't start, everything lit up on the dashboard
forums.nasioc.com > ... > NASIOC Technical > Service & Maintenance
Sep 12, 2004 - 3 posts - 3 authors
The car has been running fine, but recently in the morning especially, it won't turn over. I crank it and its trying to start, but there is no spark.
Car won't start, cranks but no start. - NASIOC - North ...
19 posts
Aug 26, 2013
car wont start, getting fuel and spark - NASIOC - North ...
5 posts
May 22, 2012
HELP: Car won't start after timing belt change - NASIOC ...
19 posts
Sep 23, 2008
Weird starting problem--1993 Impreza - NASIOC ...
9 posts
Mar 4, 2003
More results from forums.nasioc.com
www.clubwrx.net/.../134323378-my-1993-
impreza-wrx-
wont-
start-pleas...
Dec 5, 2009 - 7 posts - 2 authors
can anyone help me, my 1993 impreza wrx wont start, 2 days ago i went to ...ClubWRX Forum - Subaru Impreza WRX and STi Community and ...
10/24/2015 4:41:23 PM •
1993 Subaru...
•
Answered
on Oct 24, 2015
•
605 views
1993 Subaru impreza wagon cranking but will not start not getting fuel to the engine
Could be all sorts of things. If the timing belts have slipped, the engine will usually not start or run really rough. Could be the crank angle sensor (under the alternator, just above the main pulley).
If the belt has slipped, you can check by pulling the cam belt covers off. Usually its the LHS side belt that's jumped. The hydraulic tensioner sometimes works loose and detensions the belt. Rotate the engine till to top dead center on the pulley, and see if the cam pulleys are at the timing marks. If the belt has slipped, you WILL have bent valves.
2/24/2015 8:02:32 PM •
1993 Subaru...
•
Answered
on Feb 24, 2015
•
186 views
Misfire/Backfire and not accelerating properly wondering whats the problem?
1st get a new air filter I recommend a quality brand like the oem one or purolator.
2nd remove and clean the maf sensor. Start with the screw clamp on the intake hose. Then unplug the sensor just squeeze the tab and wiggle it off. Now remove the 4 - 10mm boltsthat hold the maf sensor on the air box. Use caution as some models have a housing with brackets that are loose when the above 4 bolts are removed.
Next clean the air flow sensor using crc maf cleaner or other maf sensor safe cleaner. This is necessary as the sensor gets dirty as the miles accumulate. Make sure the sensor wires are very clean and let it fry for 30 mins before re-installing the sensor.
I would inspect the blower motor for debris as a 93 impreza doesn't have a cabin filter.
You can access the hvac fan from under the glove box see the attached video for how to. I know its not the correct subaru but the procedure is the same.
1/30/2015 9:38:20 PM •
1993 Subaru...
•
Answered
on Jan 30, 2015
•
410 views
Engine squeal with belts off
Hello-
I assume you mean the belts are squealing when you replaced the belts. You should not run your car without the belts - damage may result.
Squealing belts usually mean they are not on tight enough (loose). Refer to your car's belt replacement instructions to determine how to increase their tension. Belts can be damaged and accessories (such as power steering, water pump, etc) not function correctly if the belts are not tensioned properly.
4/2/2014 3:15:38 AM •
1993 Subaru...
•
Answered
on Apr 02, 2014
•
148 views
Astra 17cdti loss of power steering
Are you sure when you bump started the vehicle didn't cause any
unexpected contact and cause a shortage as a result to blow the steering fuse link? Check the fuse link for the steering.
3/2/2014 6:57:17 PM •
1993 Subaru...
•
Answered
on Mar 02, 2014
•
116 views
Not finding what you are looking for?