20 Most Recent
2002 Mercury Villager - Page 4 Questions & Answers
Stopped at store. Came out....engine cranks but
Did you check your fuses in fuse compartment. Did your ever check the supply voltage of the distributor if no voltage check loss connector and fuse blown. If the voltage ok. Check the high voltage transformer if no high voltage check loss connectors, 12 volt supply may be missing or the resistor is open. The problem only circulate on this distributor system.
Where is fuze for cruise
go to villager quest yahoo group for help.
owner manual has fuse locations. one box under hood by battery - chart on cover.
other under dash driver side
OmDo you know the wiring
Match up the black wires (signal ground), the gray wire from the car to the white wire on the sensor (this is the signal wire), and the white wires on the sensor to the blue and yellow wires on the car (these are the heater wires and it doesn't matter which of the white wires on the sensor mate to the blue or yellow wires).
COMPUTER SAID TO REPLACE KNOCK
blessdwth3, Your knock sensor is a round unit that is about an inch and a half in diameter and is usually located on the back side of the engine block, usually near the middle. Just unscrew it to replace it and put wire back on. The speed sensor is usually located on the transmission on the long side extending to the right side of the vehicle. Take out the hold down and pull straight out, a little twisting motion will help with this. Put in new sensor and hold down bolt and replace wire. If you have a code reader then use this to clear the codes. If not, remove the negative battery wire (black wire) for about a minute and this will erase the codes.
Not finding what you are looking for?