20 Most Recent 2004 Honda Odyssey - Page 3 Questions & Answers

Your vehicle might not have a flasher relay. Vehicles using a CAN-bus system often use a single ECU to carry out all vehicle functions where timing is required - flashers and hazard flashers, courtesy light, wiper delay, etc. I suggest you check a wiring diagram for your car to discover what system it has.

Where is this code showing? What symptoms do you have (fever swelling of the legs and arms and so on)?

I had the EXACT same thing happen with my 2 year-old and our 2006 Odyssey last week! I drove to the dealer today to have them remove it and after banging hard on the side of the DVD player for several minutes, they said it was really stuck and I would have to pay $400 to have the DVD player removed and sent to a repair center. What!?!?!

I came home and decided to try the tweezer idea. I am not handy and I'm eight months pregnant so I couldn't get as close as I would have liked to the DVD player but as soon as I propped the little rubber doors open with the tweezers to take a peek, I saw both DVDs!! I pulled the top DVD out in about 3 seconds. I then turned my car on and the second DVD popped right out!! :) I put the DVD back in to make sure everything worked and it did. I CANNOT believe I was considering spending $400 AND be without a DVD player for weeks while they shipped it off. The DVD I pulled out has a scratch from where the tweezers were holding on to it but it's on the very outside of the DVD and if I do need to replace it, ... we're talking $10-$20 rather than $400 . Sooooo glad I didn't listen to the dealer this time!!! :)

We do not have radio theft deterrent codes here, but for a fee you can get them here: www.radio-codes.com

Hey ' Best deal for you solutions'.Please visit the site.

Dead BatteryI would think you checked that before coming here

The flasher relay is the likely cause buy one at you auto store.

valve clearance out of range try it sir?

Tech notes Adjusting the valves will usually fix this problem. When is the code detected? The control module monitors the crankshaft speed and has detected a misfire condition Possible symptoms - Engine Light ON (or Service Engine Soon Warning Light) - Lack/loss of power - Hard start - Engine hesitation P1399 Honda Description When a misfire occurs, engine speed will fluctuate. If the engine speed fluctuates enough to cause the Crankshaft Position (CKP) sensor signal to vary, the Engine Control Module (ECM) can determine that a misfire is occurring. - Valve clearance out of range

Hi,
Their is a plastic lens covering the licence plate bulb. I can be removed by using a flat-tipped screwdriver covered by a shop towel (or tape) on the right side of the lens. It should pop off where you can access the bulb.
Good Luck!

You need the radio serial #. Hold preset # 1 and # 6 at the same time, and turn on radio. The write down the serial # it is 8 digits. You can register on-line as the owner, and get the code. Or go to dealer.

- Low transmission fluid level - Dirty transmission fluid - Faulty pressure control solenoid valve 'C' - Pressure control solenoid valve 'C' harness is open or shorted - Pressure control solenoid valve 'C' circuit poor electrcial connection Read more: http://engine-codes.com/p0798_honda.html#ixzz3YiQY8JvC The Engine Control Module (ECM) uses signals from the vehicle speed sensor to detect the actual gear position (1st, 2nd, 3rd, 4th or 5th gear). Then the ECM compares the actual gear with the shift schedule in the ECM memory to detect mechanical troubles of the shift solenoid valves and valve body. Read more: http://engine-codes.com/p0798_honda.html#ixzz3YiQOwwGc

try WD-40 soak overnight, or double check park position. Possibly wiggle shift lever enough to encourage the release of the key. Proper adjustment of shift lever and links to transmission is probably needed.

Hi Nunu, Most likely the window regulator is broken, but you will need to remove the door panel to verify the issue. Hope this helps, and if you have more questions, I'll be right here.

if it cranks and does not start. its the ecu fuse, (60amp fuse) if you do not get a crank at all check the main fuse next to it, These 2 are the main culprits,

Maybe immobilizer. After iserting key wait for 10 sec., then turn it without pushing.