20 Most Recent 1996 Cadillac Seville CA Value Questions & Answers


Doing a parasitic draw test on the electrical system would be the thing to do . A couple ways of doing it ,will supply youtube video's of the best way to do it .
The BEST Way TO Perform Parasitic Draw Test

1996 Cadillac... | Answered on Dec 15, 2017


yes have your charging system checked

1996 Cadillac... | Answered on Jun 13, 2017


If you use the right spanned wench, just tigthten until it feels tight. If you Mike Tyson ask a friend so you don't strip the thread.

1996 Cadillac... | Answered on Mar 31, 2014


Hello; To change bulbs remove the cover in the trunk (pull it away) Remove the nut's/wing nuts and the assembly will come out. If you ever have to change any of bulbs that are on the deck lid you will need to remove the covering on the inside of the deck lid, remove the assembly and change the bulb.

1996 Cadillac... | Answered on Feb 15, 2014


NO HOT WATER VALVE ON THESE. HAS AUTO HAVC , NEED CODE FROM ACM. POSSIBLE ACTUATOR MOTOR. VERY COMMON BUT CODE WILL TELL YOU WHICH ACTUATOR

1996 Cadillac... | Answered on Dec 29, 2013


in the tank.. there is a chamber with the pump.. there is a tbi sensor in the tb unit that may be bad..

1996 Cadillac... | Answered on Dec 28, 2013


Yep, you have to shut the alarm off after interrupting the power supply. Use the clicker if you have one. If you have an aftermarket alarm, you may have to get the installer to look at it.

1996 Cadillac... | Answered on Sep 14, 2013


Check the fuel pressure regulator. It should have a vacuum line attached to it - disconnect the vacuum line and turn the ignition on - if fuel come out then that's your problem. DON"T do this while the engine is hot or you could start a fire!

1996 Cadillac... | Answered on Jul 29, 2013


remove upper engine cover,disconnect battery ground cable,remove throttle cable and cruise control cable from throttle body.remove intake manifold by gently lifting at throttle body end.should be enough clearance to get to starter

1996 Cadillac... | Answered on Apr 16, 2013


above center of grille ,between grille and hood,reach in flat handed and lift up flat shaped paddle

1996 Cadillac... | Answered on Apr 16, 2013


switch on top of pull down mechanism ( looks like 1 1/2 x 1 1/2 black flap of plastic ) is the switch that makes the truck latch operate. replace that switch and it will work again. did this on my 96 sts solved the problem

1996 Cadillac... | Answered on Apr 16, 2013


There is no need to purge the air out of the cooling system as it is self purging on the northstar engine.
The most common overheating problem with the Northstar engine is a blocked purge line. It's job is to purge air out of the cooling system.
There is a small diameter hose coming from near the top of the coolant tank,this is the purge line.
With the engine idling,pull the purge line from the tank,if there is no coolant flow from this small hose,it is blocked and this will cause overheating.If the hose is clear, check for blockage at the nipple on the tank or trace the hose further back until you locate the blockage.

1996 Cadillac... | Answered on Mar 26, 2012

Not finding what you are looking for?
1996 Cadillac Seville CA Value Logo

146 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Cadillac Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Seville Cadillac

  • Seville Cadillac

Most Popular Question

intake manifold contains believe

  • Cars & Trucks
Loading...