20 Most Recent
2006 Cadillac Escalade Ext Questions & Answers
Check engine light is on and off/symptoms are
When the CEL comes on a fault code or codes are stored for the malfunction in the powertrain control modules memory, so what you need to do now is have the fault code or codes read with a scan tool or a code reader. Any O'reillys or Autozone store does the test for free, just tell them you need a OBD2 fault code test run.
My engine light has come on and has went off is
try auto zone they might can read code for you (wtite code number down) then they can clear code light will come back on if problem is not corrected they normally don't charge for this service
I got a solid engine light on
You have a evap leak somewhere. You have a purge and vent solenoid. either one can be bad. also any crack in any fuel vapor line will cause this. also a weak seal on the gas can cause this. If the cap was on tight when you were directed to tighen it then you have done all you can do. You will need to get it diagnosed. But drive it for a few days first to see it thelight decides to go off. You may have a intermittant issue. You wont harm anything but the envirement if this problem is real.
I replaced the battery on my 2006 ecalade and know
Did you charge the battery first or did the store.most batterys come uncharged.if it is then id say you have connection problems on your terminals clean them with baking soda and water ..itll make the look like new
Lift gate and glass won't open
sounds like it is stuck in lock position probably the power lock actuator gone bad. does it have a key hole in it? if so try unlocking manually
How to reset alarm system in 2006 Cadillac Escalade ext
PRESS and HOLD LOCK and UNLOCK buttons at the same time on first remote for approximately 15 seconds. An acoustic signal will sound indicating successful programming. https://repairpal.com/reset-security-system-on-2008-escalade-804#:~:text=PRESS%20and%20HOLD%20LOCK%20and,will%20sound%20indicating%20successful%20programming.
6/14/2022 1:19:00 PM •
Cadillac...
•
Answered
on Jun 14, 2022
How do I remove the entire right passenger side front door on my 2006 cadillac escalade ext in order to put on my new door
The hardest part is getting the bulkhead connector unhooked. You will need to pull back the rubber accordion cover to access the connector and use a pick to get it unhooked from the pillar. Once the connector is free from the pillar it is pretty straight forward on getting the connector undone and separated. Then just unbolt the door stay and hinges and remove the door. It will make it much easier if you spend the time to remove the front fender first, this will allow you to unbolt the hinges from the pillar while the door is closed and latched instead of trying to support the door while you unbolt the door from the hinges.
4/5/2021 4:22:18 PM •
Cadillac...
•
Answered
on Apr 05, 2021
Not finding what you are looking for?