20 Most Recent 1996 Audi A4 - Page 5 Questions & Answers

I downloaded the manual for my B5 from this site : Service Manual PDF Audi A4 B5 1994 2001 pdf download and I'm very satisfied about it! Very easy to use and also you will get it instant.

Was the fan running?

um yeah it comes off with a spanner oil wrench..

you have air in the system!! you have to unbolt the filler tank and lift it 5 inch higer first. then loose the right hose on the heater core( this hose have and hole to bleed the system) and then put antifreeze until the antifreeze will go out of the hole then re install the hose to the heater core, then ajust the level correcty
have fun
jean-martin

Did you have your windshield replaced recently? If you have a photo sensor, you need to make sure replacement windshield have a cut out for this sensor.

take a copy of your vin number to your dealership, they will take your vin number and make you a key. Check right under your windshield for a number usually located on drivers side right under the glass, could be printed on your engine control computer, or in drivers side door jamb. (chassis number)

Did you found out the problem? i have the same problem and i want to find out,

The flexible brake hose is attached to a hard line on the body and should be a 14mm open end wrench and a 11mm wrench. The caliper or brake end is usually 14mm and is screwed into the caliper.All nut and bolt sizes on Audi are metric apart from the torx nuts and bolts.

Usually means power to SRS system has been interrupted. IE: If you had a flat battery or replacement battery installed and ignition key was turned on when battery flat or battery out.Will set if voltage drops below 9.5 volts during cranking too.Need a scanner to read and clear codes

With the ignition to "OFF " Position get under the seats and try by putting in your hand the connector fitted under the seat and squeeze it in your hand all seats,sometimes happen when moving the seat forward or backward to cause the connectors to become lose and there is not contact. Unless you do have a problem and it is better to call an expert using a scanner to fix it correctly and safer.

piston rings falling or exhaust leaking or no back pressure. have engine compression tested and check exhaust system for leaks or damaged box in side. hitting them usaly workis if it rattles it damaged.

Sounds like a fuse problem