20 Most Recent
2004 Chrysler PT Cruiser Questions & Answers
Why can't I start it?
Or put key in on position for ten minutes......criminals cant wait for security to reset
04 pt cruiser 2.4 turbocharged when coming to a complete stop and ac is on the car wants to die
Hi there's this website something like reliable-store and it is very amazing for manual for repairing servicing anything
someone on fixya recommended it to me and I thank him even today
They have full manuals and it's verrrrry cheap and mine
I got free in offers
3rd time I bought it, I also had an issue with the file so the girl replaced it in 30 mins
there is one website more but i don't remember its name it was 2 years back bitman something link this
Try these out brother
How do you setthetime on a 2004 pt cruiser
Clock Setting Procedure (digital clock page 242 of your owners manual)
1. Press and hold the time button until the hours blink.
2. Adjust the hours by turning the right side Tune/
Audio control.
3. After the hours are adjusted, press the right side
Tune/Audio control to set the minutes. The minutes will
begin to blink.
4. Adjust the minutes using the right side Tune/Audio
control.
5. To exit, press any button/knob or wait 5 seconds.
SETTING THE ANALOG CLOCK (page 238 of your owners manual)
To set the analog clock at the top center of the instrument
panel, press and hold the button until the setting is
correct. The clock will adjust slowly at first and then
quicker the longer the button is held.
Chrysler code P0572 need help
Trouble Code: P0572
Brake Switch Signal No. 1 Circuit Low
Trouble Code Conditions:Ignition is on. When PCM recognizes that brake
switch is mechanically stuck in the low/on position, a DTC will set.
Three global good trips are necessary to turn off MIL.
Possible Causes:
* Brake switch signal circuit is shorted to ground
* BS No. 2 signal open
* Brake switch is damaged or has failed
* PCM has failed
i would check the brake switch first located under dash and when brake is pushed it hits switch turn ignition on and test the wires if all hot then switch is bad, other wise there is a short or bad pcm and these are not easy fixes requires knowledge of car wiring and diagnostic tools/computer
My steering wheel is not lock and my ignition key is locked and the key wont turn but the sterring wheel is
My friend is a part time mechanic he gets his solutions from
www.reliable-store.com he gets from their every single detailed info, instructions, diagrams, error codes, troubleshooting, transmission etc. everything on all
vehicles, and factory manuals for service, repairs, parts, owner's, operations, maintenance etc.
U can get help from there
there is a girl at chat she can help you
My 2004 chrysler pt cruiser
Testing the starter electrical circuits is how to find the problem . Viewing wiring diagrams to see what all is involved in the starting of your vehicle ? Most vehicles have a starter relay that is energized by the PCM/ECM - engine computer . B+ voltage comes from the ignition switch going through the starter relay control side to the PCM - which will ground that circuit turning on the relay sending B+ voltage to the S terminal on the starter solenoid .
Do you know what a automotive relay is an how to test ? How to test for B+ voltage at the starter ? How to use a DVOM - digital volt ohm meter ? Free wiring diagrams here
http://www.bbbind.com/free-tsb Enter your vehicle info. year , make , model and engine size. Under system click on engine ,then under subsystem click on charging system . Click the search button then the third blue link , this is the starter electrical circuit . This diagram doesn't show the park neutral safety switch input to the PCM . Speaking of the park neutral switch , put transmission in neutral an see if it starts then , could be the switch is bad .
Intermittent no crank problem with 2004 pt cruiser
When you turn the key and it doesn't start, what happens? Do any of the dash warning lights come on? Does the engine turn over but not start?
1. If the dash lights DO come on every time, but the engine doesn't turn over every time, it's probably not a problem with the switch. Might be a bad starter relay.
2. If the dash lights DON'T come on every time, then it could be the switch (electrical contacts only working sometime). First, try spraying WD-40 or electrical contact cleaner into the lock area to see if that helps. If it doesn't, then you probably need a switch. Do a search for "ignition switch 2004 PT Cruiser" and you'll probably find what you need, including instructions. Be sure to disconnect battery before replacing the switch and follow precautions against activating airbag accidentally.
Not finding what you are looking for?