20 Most Recent 1999 Chrysler Cirrus Questions & Answers


Which engine do you have.

1999 Chrysler... | Answered on Jun 15, 2019


check that your carb floats are shutting off fuel when bowl is full.

1999 Chrysler... | Answered on Oct 27, 2017


Had the same problem on my 1999 cirrus lxi. Replaced the output speed sensor on the tranny and topped off the tranny fluid... cleared the check engine light and the cirrus ran great. Caution...the output speed sensor reqires removal of the front left tie and plastic weatherproofing to replace. once you find it's locvation, the replacement is relatively easy.

1999 Chrysler... | Answered on Oct 06, 2017


I would tend to think it was the head gasket, but it could be almost any of the gaskets / seals within the engine. If you get oil and water mixing within the engine , found by iol turning gloopy white I would be more sure about the head gasket. I did not think that head gasket replacement was really expensive, certainly less than valve covers.. Sorry can't be more helpful without seeing it and that is not possible.

1999 Chrysler... | Answered on Feb 27, 2017


The latch is adjustable on both the trunk lid and the body.

1999 Chrysler... | Answered on Jan 22, 2017


Have you done a search on YouTube? Lots of how to videos there.

1999 Chrysler... | Answered on Dec 14, 2016


Sounds like you engine is overheating. Have you checked to see if your radiator fans are working ? Check fuses and also for any codes on your ECM

1999 Chrysler... | Answered on Nov 25, 2016


Hi Shauna, do you know where to look for your hazard flasher relay ? If you still have the vehicles Owners Manuel it will be in there, If not you will need to find the Fuse panel under dash, There in the fuse panel will be a round, silver or even square object coming out of the fuse panel, It will have two prongs sticking out of when you pull it out, That is the Turn Signal/Hazard flasher relay, There also my be two of them in Fuse Panel. pull both out and replace there not very expensive.Hope this Helps, Good Luck Randy.

I’m happy to assist further over the phone at https://www.6ya.com/expert/randall_d932ef6e01588b0f

1999 Chrysler... | Answered on Aug 10, 2015


Did you check voltage and ground wiring for problem brake lamp? White wire with tan tracer is voltage for brake lamp. Black wire is ground. You need good voltage and ground. You can use a test light to check voltage and ground. Note the diagram.
25786114-h5pihne3xozhueegpkjnfspz-1-0.jpg

1999 Chrysler... | Answered on Jul 17, 2015


check wheel bearings
check brake pads and rotors
I would go for failed wheel bearings

1999 Chrysler... | Answered on May 26, 2015


Stuck doors or broken connection

1999 Chrysler... | Answered on Apr 14, 2015

Not finding what you are looking for?
1999 Chrysler Cirrus Logo

361 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Cirrus Chrysler

  • Cirrus Chrysler

Most Popular Question

1999 chrysler cirus 2 4 blinkers hazards

  • Cars & Trucks
Loading...