20 Most Recent
1998 Chrysler Concorde - Page 7 Questions & Answers
When trying to start the
Make sure the battery cables are tight to the posts. The starter takes alot more current than the headlights and will require more tight of a connection.
My speedometer stopped working, the
You will need a speed sensor it at the tail of thhe transmission the very last one is speed output sensor or vss (vehicle speed sensor) NOT input sensor
IT is overheating.I have already
you probably have either the 3.2 or the 3.5 v-6. as 15 years as a chrysler tech, i would say you need a minimum of head gaskets replaced. compression is very low. but remember this, the heads have to be checked for flatness, and if they are warped over 6 thousandths they will have to be replaced. Don
98 chrysler concorde
its possible that a sensor has gone bad,have it checked out by a transmission shop to find out what it is and what may have caused it.
Having problem with starting, appears
That symptom can be a bad fuel pump, but is usually a bad crank position sensor. Have a helper turn the key to run position while you listen at the gas tank filler tube with cap removed. If you hear a 'hum' for a few seconds, probably not fuel pump , but a fuel pressure test at engine supply will eliminate bad pump pressure. If pressure OK, replace crank sensor. Seen this many times. Sensor will cause hard/no start condition and/or fail after engine heats up after 10-15 mile of driving.
I have no brake lights.
Brake light switch could be in need og adjustment or it could be disconnected or defective.
Not finding what you are looking for?