I need the diagram for the serpentine belt on a 2005 Suzuki forenza
HI. Here is the belt diagram you need below:
Posted on Aug 26, 2010
2005 suzuki forenza how many quarts of oil does it hold
2005 SUZUKI FORENZA 2.0L 4-cyl Engine Code DOHC
Engine Oil capacity with new filter is 4.3 quarts.
Be sure to recheck oil level after engine has run for 5-10 minutes. Do not overfill.
Please rate this answer by clicking on the "HANDS" below.
Posted on Feb 09, 2011
OBD II code P0133 (O2 bank 1 sensor 1) which sensor is this, before or after the convertor.
The car runs great except the check engine light came on and this is the code it displayed.
It is the front sensor, if your car is the type that has 2 front sensors it will be the one closest to the timing chain / belt (left hand side of engine)
Posted on Nov 27, 2009
check transmission fluid on a 2005 suzuki forenza
I have a 2005 suzuki forenza,where is the transmission dipstick located at under the hood. Thank you!
Posted on May 23, 2012
Trying to remove inner door panel without breaking hidden plastic clips. This I guess is the first step to remove broken and install new door handel.
you answered your own question,ease the door panel with two screwdrivers ,one either side of the plastic clip and watch for the mastic
Posted on Jan 23, 2009
2005 Suzuki Forenza warning light: Right side of dash, looks like a steering wheel with exclamation point to the right of it....Power steering seems fine and fluid is full. What is this?.....Thank you!
Speed Sensitive Power Steering (SSPS) Warning Light Your vehicle is equipped with Speed Sensitive Power Steering (SSPS). This is a computer-controlled power steering assist system. The warning light you are describing will come on briefly when you turn the ignition to ON as a check to show you the bulb is working. Then it should go out after a few seconds. If the warning light does not come on, have it fixed so it will be able to warn you if there is a problem. If the warning light stays on, or comes on while you are driving, the SSPS system may not be working.
Your computer will need to be scanned to determine what the problem is with your SSPS system.
Posted on Jan 23, 2011
Timing belt marks
old post. shows as 2016 so i bumped it.
OP fails to seach first.
http://www.fixya.com/search.aspx?ref=ser&s=forenza%20timing%20marks&
Posted on Jan 02, 2017
How do you remove the headlight assembly
there is a nut on the left side of the light on drivers side,just the opposite on passenger side. you will need a deep socket. there are 2 10mm bolts on top of the assy. and on the back is a 10mm nut you will have to remove on order to remove the assy.
Posted on May 15, 2008
replace front wheel bearing 2006 suzuki forenza
Very easy. Pull the wheel off after lifting the car on the side you're fixing. ;) Then pull the big center nut off the spindle. It's got a safety smash down you will have to lift up that's in a grove on the shaft. You will see this once the wheel is removed. Unbolt that big nut then pull off the brake rotor. The bearings are in the brake rotor and the shaft the rotor was sitting on. Change them both and be back on your way. It's a 20 min job at most for a beginner.
Posted on Sep 07, 2010
I replaced the timing belt on a 05 suzuki forenza and not i cannot figure out which mark to use on the exhaust cam pulley
Regards,
Tony
Posted on Oct 10, 2011
681 questions posted
Usually answered in minutes!
790 Questions
537 Questions
284 Questions
46 Questions
9 Questions