20 Most Recent
1999 Plymouth Breeze Questions & Answers
How do I change a alternador in my 1999 plymoth
1 remove battery cables from battery 2 disconnect wires from alternator 3 loosen belt with the belt tensioner it will probly take a 3/8 drive ratchet to loosen the tensioner by putting the end that normaly goes into socket into a square hole in tensioner( just move tensioner far enough to slip belt off alternator pully) 4 remove bolts from alternator 5 put new alternator in place and put bolts in 6 put belt back over pulley 7 plug wires back on alternator 8 reconnect battery
Does a 99 Plymouth breeze havean inertia switch to shut fuel off
here is no switch.However, it does have an ASD relay (ASD = Auto Shut Down) that controls both spark and fuel. This relay on your car is in the fuse/relay block under the hood and should be clearly marked as "Shut Down" or "ASD" on the fuse/relay chart on the cover. These are easy to check since there are often several different relays that are the same in that block. Take one from a known good source such as A/C (just make sure the numbers printed on the top of the relay are the same) and swap them to see if it will start.
I have a 99 plymouth breeze I change the fuel pump
Have you had the vehicle hooked to a diagnostic scanner ? Check the ASD relay ? - auto shut down relay . Relay's do go bad . The ASD relay on your vehicle power's fuel pump , ignition coils ,fuel injector's ,O2 sensor heaters etc...
Rattling noise in ignition
Replace The Starter !! Also Be Very Careful When You Pull The Starter Looking For Bolt's And Nuts That Might Have Been Rolling Around Possibly From Vibration!! Again By The Description Of What You Have Stated Sound's Like The Starter (Did You Try To Jump The Solenoid To The Starter?)that would be a reassurance that the starter was bad if you did try to jump the (S) On The Solenoid To The Positve + The Starter Should Turn Over If it Just Spark's And You Are Sure the Battery Read's At Least 12.4 VDC Then Your Starter Is Bad!!!
(Hope This Help's) Best,
Rattle coming from plate under car
Without knowing what kind of vehicle make model and year, I can not help. But, I would suggest instead of removing it, I would suggest try using expanding foam in a can that you can get at all hardware stores. But be careful not to go to crazy with that stuff!
And, not to get the heavy expanding stuff!
This should expand and it also works as a glue and a sound barrier so it should solve your problem!
Hope this helps.
I own a 1999 Plymouth
Open trunk. Remove the threaded wing nuts on each tail light assembly. With the wing nuts off, pull the entire assembly out to exposed the sockets.
1999 plymouth breeze 2.0 l battery and alternator are good but the engien wont crank unless you jump start it
You have to make sure battery has a full charge and that means testing. Your saying the starter motor won't even crank the engine? I'd have to check starter wiring circuits for voltage drop?Also, make sure battery connections are good. Engine cranking, your systems get battery voltage. Engine running, the vehicle system get generator voltage which can be several volts higher than battery voltage.
Use a digital multimeter across battery posts, everything off, what is the reading, the generic spec for a full charge is around 12.6 volts. Leave the meter leads hooked up, have helper turn key to crank, what is the reading, how far does it drop? The generic spec says it shouldn't drop below 9.6 volts, that spec may be subjective but, close.
Not finding what you are looking for?