20 Most Recent
2006 Jeep Wrangler - Page 3 Questions & Answers
Wire broke off on oxygen sensor plug.
See if you can open up the connector & repairIf not-- cut off 6" of wire with the correct connector,at a salvage yard, & solder & heat shrink to yourharness
3/28/2013 12:26:37 AM •
2006 Jeep...
•
Answered
on Mar 28, 2013
06 wrangler blower fan stops working
I'm not following your story.Does the blower motor stop working from time to time ?Have you checked the motor for power and ground when it is not working ?
2/12/2013 12:27:15 AM •
2006 Jeep...
•
Answered
on Feb 12, 2013
2004 or 05 Jeep Wrangler dtc P2096
Here is more information about P2096
P2096-DOWN STREAM FUEL TRIM LEAN BANK 1
WHEN MONITORED
With the engine running in closed loop mode, the ambient/battery temperature above (-7°C) 20°F , altitude below 8500 ft and fuel level greater than 15%.
SET CONDITION
If the PCM multiplies short term compensation by long term adaptive and a certain percentage is exceeded for two trips, a freeze frame is stored, the MIL illuminates and a trouble code is stored. Two Trip Fault. Three good trips to turn off the MIL.
Here are some possible casuses:
Exhaust leak
Engine mechanical problem
02 sensor
02 signal circut
02 return circut
Fuel contamination
Good luck and hope this helps.
2/10/2013 4:11:44 AM •
2006 Jeep...
•
Answered
on Feb 10, 2013
06 Wrangler...steering pump noise..whines when
No pump should be noisy, though if only noisy when wheels are turned all the way to either side, that is normal. Once turned to the point where the pump first begins to make noise you really don't have any more wheel movement and turning the steering wheel further does very little except cause the noise. I've found that on many Jeeps the steering stop bolts on the lower control arms are set too far in and can be turned back a bit. That may help somewhat.
1/14/2013 5:15:51 AM •
2006 Jeep...
•
Answered
on Jan 14, 2013
Not finding what you are looking for?