20 Most Recent
1998 Jeep Wrangler - Page 7 Questions & Answers
1998 Jeep Wrangler stalls intermittently
Remove your overflow bottle and ECM remove the screws on face of ECM and add a small flat washer to each re install clean contacts on ECM plugs and re install bottle. should correct the problem.
3/19/2013 4:17:48 AM •
1998 Jeep...
•
Answered
on Mar 19, 2013
My jeep cuts off while driving, no shaking or stalling, just turns off. Then it will cut right back on and keep going.
Hi there,This does sound like an electrical issue.However, you should NEVER replace any component, until you have extracted your vehicle's OBD codes.Do this by the following method:• Rev the car to 2500 rpm (while in Neutral or Park), then slowly reduce revs down to idle.• If equipped with automatic transmission, cycle through each position (Drive, Park, etc).• If equipped with air conditioning, also cycle that ON and OFF.1 Turn engine OFF.2 Retrieve the trouble codes: turn the ignition ON-OFF, ON-OFF, and finally ON again (within 5 seconds).3 The stored 4-digit fault codes will be displayed in the odometer (speedo) display area.Reply back with these codes and we can assist you further.Cheers,
2/22/2013 9:54:17 AM •
1998 Jeep...
•
Answered
on Feb 22, 2013
2005 wrangler sputter
Have the computer scanned to see if there are any codes stored, there are auto part stores that will scan the codes for free . let me know if there are any codes.
12/8/2012 4:58:07 PM •
1998 Jeep...
•
Answered
on Dec 08, 2012
Not finding what you are looking for?