20 Most Recent 2005 Chrysler PT Cruiser - Page 9 Questions & Answers

see other notes

Jesse A Shelby, my best guess is the (transmission control module) you said check engine light is on that means codes are being stored , OBD needs to be scaned that's a start. (interesting name). Woody.

http://engine-codes.com/p0032.html http://engine-codes.com/p0038_chrysler.html Could be as simple as a popped fuse. Also check the wiring surrounding the sensor, could be exposed or frayed

Hi Bob I'm glad to help! Bob, first, unplug all electrical connectors from the throttle body. Then if equipped take the bolts out of the EGR Tube at the back side near the throttle body. Next, there one bolt that goes through a bracket right next too the EGR Tube. Then remove the bolts that are facing downward on the intake. Then pull it up and outward toward you. The gaskets are reusable, so put it back in reverse procedure. NOTE: Sense you're already there save yourself from having to redo the job by replacing the spark plug wire too. Hope this helps and have an awesome day Bob.

This would be very good justification for you to buy a cheap OBDII scanner through Amazon or your local auto parts store. Next time it happens, plug the scanner in immediately and read the error code(s) out of the computer. Then you'll know what's happening. The failure is intermittent, whatever it is, so you need to catch it while the error code is still "live".

It's very likely that you have one or more blown fuses.

Blown fuse, bad switch, broken wire, or burned out bulbs.

Some oil additives work some what. I dont know of any that will help with this problem. The valve seals are dried out and a mechanic in a can wont help much if any.

P0508 Chrysler Idle Air Control Valve Sense Circuit Low http://ww2.justanswer.com/uploads/CH/chrlsman/2014-01-30_213314_1.gif http://images.oreillyauto.com/parts/img/medium/bwd/50554_primary.jpg Check wiring and plug that goes into valve. Valve can be replaced.

Then you have no air bag turned on, if you were to need it Get it into a shop Any dash light on after the motor is running, is a system fault, & needs to be diagnosed & repaired within a week or less

Internal to the switch you probably need a new switch

INSTALL NEW TIMING BELT KIT . WILL FIX IT.

Possible bent valves