20 Most Recent
1999 Audi A6 Questions & Answers
2007 holden captiva air bag light staying on
Hi Jeremy!
WOW! thank you very much about your tips!! I fix my airbag light just moving the yellow wire under my driver seat at NO COST!!
I got Captiva LX 2007 and the airbag lights on for month and I know Holden dealer charge a lot for any repairs!
Airbag light on - fixed now!! Thanks again!
Now i need to fix my Engine light - Holden dealer quote me for 4K-6K to replace the timing chain..
I got quote from the local mechanic for $2400 ---- a lot cheaper!!
Cheers
MItz
10/20/2018 10:05:47 AM •
1999 Audi A6
•
Answered
on Oct 20, 2018
My xenon headlights on my 99 Audi A6 don't always
I recently tried the DIY service and repair manuals from a website and it actually helped me repair transmission problem in my jcb 3cx site-master. It would'nt move forward or reverse, engine was good both solenoids for forward and reverse worked, but still couldn't diagnose the problem.
I don't have much technical knowledge but I just followed it step-wise, and now it works perfect!
covers wiring, codes, diagrams, torque specs, PCV, everything
got it from
www.reliable-store.com
3/22/2018 4:38:55 PM •
1999 Audi A6
•
Answered
on Mar 22, 2018
Audi A6 1999 airbag light is on , how do I get it off?
The first thing to do is have the Airbag system scanned for fault codes. The code will point you to the problem. Have you had any front end damage repaired recently? If so check the wiring and/or the impact sensor. If no codes are found, replace the clock spring under the steering wheel, following all appropriate safety instructions.
1/3/2018 1:52:34 AM •
1999 Audi A6
•
Answered
on Jan 03, 2018
How do open the hood
Under the car:
You will be able to open the hood if you pull off your splash guard and use a long long flat head screwdriver or something like that. You'll see the hood latch in front of the radiator with the cable attached to it at the top near the hood, put it on the drivers side edge of the bottom of the latch and pry to the passenger side, the lever moves from the drivers side to the passengers side, the cable basically pulls the top of it to achieve this. so your doing the same thing on the bottom with the screwdriver.
Release the latch from underneath by the lever that you have to pry towards the passenger side. Then open the hood, and replace the safety release mechanism broken cable.
6/3/2017 2:20:13 PM •
1999 Audi A6
•
Answered
on Jun 03, 2017
1999 Audi A6 gear shift not moving, even with break applied
The lock shift solenoid that works withe break pedal has gone bad... it's located next to or In front of the shifter.. on some vehicles. You have a key slot that you can use another key or small screw driver in it to unlock the shifter. Just replace that and it should be fine..
4/22/2017 9:59:19 AM •
1999 Audi A6
•
Answered
on Apr 22, 2017
My audi A4 radio will not turn on. its almost
In back side of the radio, (for Audi A4, A6 - year 1999), you will find a blowed fuse = 10A (red colour). Replace it and that's all. Also:
IMPORTANT NOTE: You must have the security anti-theft code for yours Audi Concert radio from the car manufacturer! For Audi Concert the sequence of programming is:
1. Push simultaneous "SCAN" and "RDS" keys until on the screen will appear "1000" displayed.
2. Release keys. No more push on "SCAN" and "RDS" keys because otherwise number "1000" will be considered as first safe code attempt.
3. By the #1 key you will set up the first safe code digit.
4. By the #2 key you will set up the second safe code digit.
5. By the #3 key you will set up the third safe code digit.
6. By the #4 key you will set up the four-th safe code digit.
7. Then push again simultaneous "SCAN" and "RDS" keys for confirm this safe code. On the screen will be displayed "SAFE" notice. Release keys! For few seconds a radio frequence will be displayed. The radio is now ready for use!
1/30/2017 12:01:18 AM •
1999 Audi A6
•
Answered
on Jan 30, 2017
Not finding what you are looking for?