20 Most Recent
1997 Ford Windstar Questions & Answers
How do i reprogram electronic door locks
Programming Electronic Door Lock Control System
NOTE: The electronic door lock control processor (14B001) erases all
previous keyless entry remote transmitter (15K601) from memory when the keyless
entry remote transmitters are programmed or reprogrammed. The electronic door
lock control processor can store up to four keyless entry remote transmitters in
memory.
- To program (or reprogram) keyless entry remote transmitter into the
electronic door lock control processor, perform the following steps:
-
Turn ignition switch to the RUN position and momentarily short the two
terminals of the program connector taped to the wire assembly and located behind
the glove compartment. All doors should lock and then unlock. Remove shorting
pin.
-
Press any button on keyless entry remote transmitter. All doors should lock
and then unlock to verify the keyless entry remote transmitter has been
programmed. If door locks do not respond, press button again (up to three times
maximum with the same keyless entry remote transmitter).
-
Repeat the above step to program additional keyless entry remote transmitters
into the electronic door lock control processor (up to four keyless entry remote
transmitters maximum).
-
Turn ignition switch OFF. All doors should lock and then unlock.
-
Check operation.
5/22/2018 7:33:36 PM •
1997 Ford...
•
Answered
on May 22, 2018
Will 16 inch tires fit on a 97 ford windstar
If the stud pattern and off set is the same they will fit on. The problem is that regulation requires the ride height to be maintained which means that you will have to fit a lower profile tyre . For example if you use 15 " 205/95-r15 tyres then you may have to go to 205/65 r16 tyres . Talk with a tyre shop and discuss the legal requirements as far as insurance goes with a wheel size change
5/27/2014 6:05:34 PM •
1997 Ford...
•
Answered
on May 27, 2014
Transmmision jumps
Our 97 ford wind star would jump after coming to a complete stop...i found a hose that sit on the manafold was off.....(look On top Or in Back) problem solved
5/26/2014 4:52:17 AM •
1997 Ford...
•
Answered
on May 26, 2014
Won't start
Does engine turns at all and just won't start?
5/5/2014 5:58:27 PM •
1997 Ford...
•
Answered
on May 05, 2014
Ford windstar fuel pump relay
Reset the inertial switch (collision safety switch), located inside a compartment accessible from the inside of the vehicle, near the driver side rear lights. There should be an extruded red button which you press in to reset.
4/14/2014 10:24:36 PM •
1997 Ford...
•
Answered
on Apr 14, 2014
Overheating
Stuck Relay for electric cooling fan. Dirty connections from Fan relay to cooling fan.
3/1/2014 5:15:27 AM •
1997 Ford...
•
Answered
on Mar 01, 2014
Not finding what you are looking for?